User manual

3. Thread the power cord through the base of the sound enclosure

and the counter top hole being careful not to scratch or damage the

enclosure.

4. Gently place the motor base into the sound enclosure and slide it into the

hole in the counter top. Make sure the LCD indicator and touch pad are

facing the operator’s side of the counter. Also ensure that the rubber

gasket on the motor ﬁts snugly and evenly into the sound enclosure and

counter top holes. (If you do not have a sound enclosure the motor base simply ﬁts

into the hole in the counter top.

5. Re-install the sound enclosure lid.

6. Plug the unit into a receptacle with a dedicated circuit and appropriate protection.

Make sure power switch is turned off before plugging unit in.

SECTION 5: OPERATING INSTRUCTIONS

5.1 OPERATIONAL OVERVIEW

1. If blender is not turned on, turn on the main power switch located on the front of the

blender motor.

2. Place the properly ﬁlled blender jar on the motor, making sure the jar is seated all

the way down and jar lid is secured tightly on the jar.

3. Press the desired button on the touchpad.

5.2 MANUAL OPERATION

This machine is equipped with button activated electronic speed controls. Motor

speed and run time are indicated on the LCD display. Speed 1 is the lowest speed,

and speed 20 is the highest. On the right hand side of the touchpad are an UP

and DOWN button. Pressing the UP button once will start the motor at speed four.

Pressing the down button will start the motor at speed 1. Holding the speed up/down

buttons down will cause the motor speed to ramp up or down. Pressing and releasing

these buttons will cause the motor to speed up or down by one speed level.

When the blender is started using the up/down buttons, the count down timer is set

for 60 seconds. Additional time (up to a total of 90 seconds) can be added at any

time during the cycle using the +5 SEC TIME SELECT button, and the blender can be

stopped at any point using the STOP button. The blender can also be started at speed

4 by pressing the + 5 SEC TIME SELECT button

Pressing the LOW PULSE button will run the motor at speed 9 until the button is

released.