Operating instructions

Page 7
SECTION 4: INSTALLATION
4.1 Xpress Installation
1. Place blender on a at, clean, dry surface.
2. Make sure plug outlet is available within four feet of the motor base.
3. Plug the unit into a 220/240 volt receptacle with 7.5 amp protection.
Make sure switch is turned off before plugging in. Failure to use a
dedicated line may result in damage to the blender. Lack of adequate
power causes the motor to overheat (which shortens the life of the
blender electronics.) Operating the blender in this manner will void the
warranty.
4. Ensure that the blender vents are unobstructed to allow for proper
cooling during use.