Operating instructions
Page 11
5.6 LONG-TERM SANITATION OF JAR
1. For long-term sanitation, periodically ll the blender jar with hot tap
water.
2. Add non-chlorine sanitizer according to manufacturer’s specications.
3. Empty water/sanitizer mixture. Store jar as described in section 5.5.
5.7 DAILY CLEANING OF MOTOR
1. Make sure the main power switch is off and motor is unplugged before
cleaning.
2. When necessary, wipe the top and sides of the blender clean with a
damp rag. Mild cleaners like WINDEX® may be used.
5.8 WEEKLY CLEANING OF MOTOR (Done in addition to daily
cleaning while motor is unplugged and removed from enclosure)
1. Fill the blender drive socket (see gure 1.2) with a strong cleaning
solution. DO NOT OVERFILL. Let stand for 5 minutes.
2. Clean the inside ridges and grooves of drive socket with a toothpick,
an ice pick or some other hard, pointed tool.
3. Turn the motor upside down to drain the material from the drive
socket. Use a paper towel or rag to dry the area and replace the motor.
5.9 CLEANING TIPS AND CAUTIONS
● Do not use abrasives to clean the blender motor or jar as this will dull
or scratch the surface
● Do not use a water jet of any kind to clean this equipment.
● NEVER submerge the blender motor in water - THIS WILL VOID
WARRANTY
● Avoid submerging the blender jars for more than 5 minutes. Water
penetration through the lower jar seals will reduce the jar life. When
you have cleaned the jar, store it upside down. Do NOT allow water to
stand in the lower seal area.