User Manual

SECTION 2: UNPACKING

SAVE ALL PACKAGING MATERIALS AND INSTRUCTIONS FOR FUTURE USE

2.1 UNPACKING YOUR BLENDER

You should have received the following items:

• Designer series blender motor base

• Blender jar with lid

• Blendtec 101 booklet

• Customer Service and Warranty Registration Card

Additional literature may be included depending on package conﬁguration

1� Remove blender motor base, blender jar, and lid from packaging�

2� Unwind the power cord�

3� Check for any packing material that may have blocked ventilation holes on the

underside of the blender motor base�

4� Inspect all items to ensure no damage occurred during shipment�

5� If any damage has occurred, contact your Blendtec service agent immediately�

2.2 RECORDING YOUR SERIAL NUMBER AND DATE OF

PURCHASE

Record your blender motor serial number and date of purchase in the space

below� You will need these when contacting Blendtec for service or questions�

Motor Serial #(Found on bottom of motor base):_______________________

Date of Purchase: ____________________________________________

Purchased From: _____________________________________________

2.3 REGISTRATION OF YOUR BLENDER

SECTION 3: GETTING TO KNOW YOUR BLENDER

(Refer to Figures 1 and 2)

3.1 BLENDER MOTOR BASE

• Smart Touch Interface: Consists of preprogrammed cycles, capacitive touch

slider, and various one-touch settings, depending on model�

• Hardened Metal Drive Socket: Where the jar couples with the motor to turn the

blade assembly; made of hardened metal�

• LED Information Center: Displays the number of times a blend cycle button has

been pressed, the time left to blend, and error messages�

• Power Unit: This unit is located within the blender motor base and contains the

computerized electronics that run the blender�

• Motor Base Cover: Houses the power unit in a durable, plastic material�

• Power Cord: Located at the back of the motor base cover�