Operation Manual

SECTION 2: UNPACKING

SAVE ALL PACKAGING MATERIALS AND INSTRUCTIONS FOR FUTURE USE

2.1 UNPACKING YOUR BLENDER

You should have received the following items:

• Classic series motor base

• Blender jar with lid

• Blendtec 101 booklet

• Customer Service and Warranty Registration Card

Additional literature may be included depending on package conﬁguration�

1� Remove blender motor base, blender jar, and lid from packaging�

2� Unwind the power cord�

3� Check for any packing material that may have blocked ventilation holes on the

underside of the blender motor base�

4� Inspect all items to ensure no damage occurred during shipment�

5� If any damage has occurred, contact your Blendtec service agent immediately�

2.2 RECORDING YOUR SERIAL NUMBER AND DATE OF PURCHASE

Record your blender motor serial number and date of purchase in the space below�

You will need these when contacting Blendtec for service or questions�

Motor Serial #(Found on bottom of motor base):_________________________

Date of Purchase: ______________________________________________

Purchased From: _______________________________________________

2.3 REGISTRATION OF YOUR BLENDER

SECTION 3: GETTING TO KNOW YOUR BLENDER

(Refer to Figures 1 and 2)

3.1 BLENDER MOTOR BASE

• Touchpad: Consists of one-touch pre programmed cycles and speeds, as well as

Stop and Pulse buttons�

• Hardened Metal Drive Socket: Where the jar couples with the motor to turn the

blade assembly; made of hardened metal�

• LCD Information Center: Displays the number of times a blend cycle button has

been pressed�

• Power Unit: This unit is located within the blender motor base and contains the

computerized electronics that run the blender�

• Motor Base Cover: Houses the power unit in a durable, plastic material�

• Power Switch: Located on the back lower-right corner of the motor base cover�

• Power Cord: Located at the back of the motor base cover�