Owner's Manual
MTX
Series
Multiple Patents Pending
You will need to identify the Ground wire and the +12 volt switched wire in your
mirror's wire harness. This can be done by using a voltmeter. If you are unable
to use a voltmeter we recommend taking your vehicle to a stereo install shop.
1 - Auto dimming rear view mirrors have a
molex plug that supplies power and
ground to the mirror. This plug may be on
the back side
of
the mirror
or
within a
plastic housing on the windshield. Each
wire enters the molex plug via a rectangu-
lar port as shown by the red arrows below.
When inserting the Taps (prongs) into the
rectangular port
of
the molex plug, you
may have to try inserting the Tap in all four
sides
of
the rectangular port to determine
the best wedge fit. DO NOT use exces-
sive force trying to insert the Taps.
2 - This kit has 4 different size sets
of
Taps.
Each set consists
of
a Red and Black Tap.
The Red
Tap
is for the +12 volt switched
and the Black Tap is for Ground. Determine
which
Tap
size provides the best wedge fit
for +12 volt and ground.
3- Once you have determined the + 12
volt switched and ground wires in the
molex plug, and which size tap provides
the best wedge fit, connect the 2 Taps to
the cord assembly as shown below.
You
may choose to use the provided shrink
tubing to cover the connection between
the Taps and cord assembly.
- '
-,•
-~
=~=~
~
J28 DESIGN INC. will not be held responsible for any damage to, interference with,
or
malfunction of your vehicle's electrical
system resulting from installation
or
use
of
the MirrorTap. Consult with your vehicle's dealer for any questions about your
vehicle's electrical system. If you do not agree to these terms, do not use this product and return it for a full refund.