Owner's Manual

PART# BRD-3030
Blan
Er
d=o
Innovative
Mounting
Solutions
STEP 3 - While sitting in the passenger seat, place the mount over
the mirror stem. Tighten the CLAMP SCREW until the mount starts to
clamp onto the mirror stem. Position the mount as far forward as it will
go and paralell to the bottom
of
the mirror before fully tightening.
ROTATING
ADJUSTMENT
PIVOT
POINT
TOP AND MID
SECTIONS MUST TOUCH
AT THE PIVOT POINT
BEFORE CLAMP SCREW
IS FULLY TIGHTENED
STEP 4 - MAKE SURE THE TOP AND MID SECTIONS
ARE TOUCHING AT THE PIVOT POINT. If you can not get
them to touch at the pivot point, you have an incompatible
mirror type for this mount.
PIVOT
ADJUSTMENT
STEP 5 - Reinstall the BODY ASSEM
BLY.
Be sure to include the
lock washer with the top socket head screw and the lock and flat
washer with the bottom socket head screw as shown above. NOTE:
there are extra lock and flat washers included in the tool kit just
in
case you happen to misplace one.
STEP 6 - Install your radar detector onto the mount. Use the ad-
justments shown above to adjust the RD to your desired position.
We recommend adjusting the RD as close to the bottom
of
your
mirror as you can. Be sure to tighten all adjustment screws after the
adjustments are made.
CAUTION
DO NOT use this mount if it interferes with the adjustability
or
the operation
of
your rear view mirror
in
any way.
DO NOT use this mount
if
the radar detector creates an unsafe viewing obstruction.
DO NOT ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
-
-
-
All Blend Mount products are accompanied with detailed installation instructions and adjustment tips. You are encouraged to contact customerser rice@blend-
mount.com or call J28 Design at 1-888-497-8388 for further assistance.
Check the BlendMount Forum for installation tips and some vehicle specific installs.
www.blendmount.com
Innovative Design
And
Precision Manufacturing
PAGE 2 OF 2
Your feedback is very important to us. Please email any questions or
comments you have to customerservice@blendmount.com
BlendMount - US
PATENT#
D625,580 5, D656,
811
S, D653,980 S
D690,245 S, D690,246 S, D690,247
Sand
other patents pending