Manualshelf

Owner's Manual

ManualsBrandsBlendMount ManualsGPS & car accessoriesCustom-Fit Radar Detector Mount
12
PART# BRD-2032
Blend
ffloun
Er
-
-
-
11111
IHI
fflll
11111111111
Innovative
Mount
i
ng
Solut
ions
LEFT HAND DRIVE VEHICLE
7
28028
44292
2
INSTALLATION INSTRUCTIONS FOR RADENSO RADAR DETECTORS
Your rear view
mirror
has minimal clearance between the back side
of
the
mirror
and the
mirror
stem. It i very important
that
this
mount
is
installed correctly
to
ensure
mirror
adjustability
is
retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
NOTE:
For
illustration purpose , the mount and rear view mirror shown In these Instructions m y look slightly different then YOUR
mount and rear view mirror.
Befor installing this mount on your mirror observe how the spring clip functions. When us d properly, the spring clip avoids putting exce ive
pressure on the mirror when installing and
~
moving the radar detector (RD).
To
release tension from the spring
dip,
simply squeeze the tab and
the back side
of
the mount together. This will lower the bottom portion
of
the spring clip allowing you to slide the RD on and off the mount. Push the RD
Release button and slide the RD onto the Spring Clip until you hear it lock into position, then release both the Tab and Release Button. Install and
remove the RD a few times before Installing the mount on your mirror. Once the installation i complet , the spring clip llow you
to
access the
buttons on
top
of
the RD while still having th RD installed to sit as close to th bottom
of
the rear-vi w mirror a
po
Ible.
By
gently pushing
down on the RD the spring clip is designed to flex downward allowing you
to
push desired buttons, then it will spring back into its original position when
you take your finger away. This can also be useful! to access the release button.
TOP
SECTION
MID
SECTION
STEP 1 • Th BODY ASSEMBLY must be removed to gain access
to
the
CLAMP SCREW. Remove the two socket head screws as shown
above. Be sur
to
remove the lock washer with the top screw along
with the lock washer and flat washer with the bottom screw.
PAGE 1
Of
2
CLAMP
SCREW
STEP 2 • Loosen the CLAMP SCREW so there
is enough clearance between the TOP and MID
SECTIONS to slide over the mirror stem.

Summary of content (2 pages)