Owner's Manual
PART# BRD-2027
Blend
fflo
_u_n_ ®
Er
dED
DE
Innovative
Mounting
Solution
s
ROTATING
ADJUSTMENT
DRIVER'S PERSPECTIVE
WITH NO ROTATING
ADJUSTMENT USED
DRIVER'S PERSPECTIVE
WITH
RADAR
ROTATED
TOWARDS DRIVER
CLAMP SCREW
CLAMP
SCREW MUST
BE
SLIGHTLY LOOSENED
BEFORE MAKING
ROTATING ADJUSTMENT
BE
SURE TO RETIGHTEN
AFTER ADJUSTMENT
IS
MADE
STEP 3 • Install your radar detector onto the mount. Use the adjustments shown above to adjust the RD to your desired position.
We
recom-
mend adjusting the RD as close to the bottom
of
your mirror as you can. NOTE When the rotating adjustment is used to rotate the RD towards
the driver, the footprint
of
the RD is reduced as shown above. Be sure to tighten all
of
the adjustment screws after the adjustments are made.
STEP 4 • With the RD adjusted right below the mirror as recommended, you will probably not be able to get your fingers between the RD and mirror to
access the buttons. The spring clip allows you to push the front
of
the
RD
downward with one finger and press the buttons with another finger
as shown above.
NOTE : This mount can get extremely hot when sitting in direct sunlight. If you intend to remove your RD frequently, you may want to install the two gray
"TOUCH STRIPS" Included in the tool kit. Place them where your fingers make contact with the mount. They may be trimmed with a blade or knife.
FOR MORE INFO VISIT www.blendmount.com/videos
CAUTION
DO NOT use this mount if it interferes with the adjustability or the operation of your rear view mirror in any way.
DO
NOT
use this mount
if
the radar detector creates an unsafe viewing obstruction.
DO NOT ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
All BlendMo Jnt products are accompanied with detailed installation instructions and adjustment tips. You are encouraged to contact customerser
1
lce@blend-
mount.com or call J28 Design at 1-888-497-8388 for further assistance.
Check the BlendMount Forum for Installation tips and some vehicle specific installs.
www.blendmount.com
Innovative Design
And
Precision Manufacturing
PAGE 2 OF 2
Your feedback
Is
very important to us. Please email any questions or
comments you have to customerservice@blendmount.com
BlendMount - US
PATENT#
0625,580 S,
0656
,
811
S,
D653,980 S
D690,245
S,
D690,246
S,
D690,247
Sand
other patents pending