Owner's Manual
PART# BRD-2027
Hlend
lllount-
®
:ra
::n
-
-
-
11111111111111~1111111111!
11
Innovative
Mounting
Solution
s
LEFT HAND DRIVE VEHICLE
1
28028
41125
'
INSTALLATION INSTRUCTIONS FOR BELTRONICS AND ESCORT RADAR DETECTORS
Your rear view
mirror
has
minimal
clearance between the back side
of
the
mirror
and the
mirror
stem.
It
is
very
important
that
this
mount
is
installed correctly
to
ensure
mirror
adjustability
is
retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
BEFORE INSTALLING THIS MOUNT
ON
YOUR MIRROR observe how the spring clip functions. When
used
properly,
the
spring
clip
avoids
putting
excess
i
ve
pressure
on
the
mirror
when
installing
and
removing
the
radar
detector
(RD).
To
release tension from the spring clip, simply squeeze the
tab and the back side of the mount together. This will lower the bottom portion
of
the spring clip allowing you to slide the
RD
on
and off the mount. Push
the
RD
Release button and slide the RD onto the Spring Clip as far as it will go. Then release both the
Tab
and the Release Button. Slide the RD toward
you just slightly until you hear it lock into position. Install and remove the
RD
a few times before installing the mount on your mirror.
TOP
SECTION
'
STEP 1 • Loosen the clamp screw so the top section separates
from the mid section. This will provide the necessary clearance to
slide the mount over the mirror stem as shown above.
Innovative Design
And
Precision Manufacturing
PPROXIMATELY 1/8"
BETW
ACK
OF
MIRROR AND MOUN
STEP 2 -
Ti
ghten the clamp screw until the
Top
and Mid Sections are slight-
ly
snug
around the mirror stem.
You
should still be able to move the mount
.1long the stem. Before fully lightening the clamp screw, slide the mount towardf
the windshield as far
as
it will go. There should be approximately 1/8" between
the back of the mirror and the mount as shown above.
PAGE 1 OF 2
BlendMount -
US
PATENT# D625,580 S. 0656,811 S. 0653,980 S
D690,245 S, D690,246 S, D690,247
Sand
other patents pending