Owner's Manual
PART# BRD-2025
Blan
moun
®
dE
-
-
-
I
nnovative
Mounting
Solut
i
on
s
STEP 3 • While sitting in the passenger seat, place the mount over
the mirror stem. Tighten the CLAMP SCREW until the mount starts to
clamp onto the mirror stem. Position the mount as far forward as it will
go and paralell to the bottom
of
the mirror before fully tightening.
ROTATING
ADJUSTMENT
STEP 5 • Reinstall the BODY ASSEMBLY. Be sure to include the
lock washer with the top socket head screw and the lock and flat
washer with the bottom socket head screw as shown above. NOTE:
there are extra lock and flat washers included in the tool kit just in
case you happen to misplace one.
CAUTION
PIVOT
-~
POINT
TOPANDMID
SECTIONS MUST TOUCH
AT THE PIVOT POINT
BEFORE CLAMP SCREW
IS
FULLY TIGHTENED
STEP 4 • MAKE SURE THE TOP AND MID SECTIONS
ARE TOUCHING AT THE PIVOT POINT.
If
you can not get
them to touch at the pivot point, you have an
Incompatible
mirror
type
for
this
mount
.
STEP 6 • Install your radar detector onto the mount. Use the
adjustments shown above to adjust the RD to your desired posi-
tion. We recommend adjusting the
RD
as close to the bottom
of
your mirror as you can. Be sure to tighten all adjustment screws
after the adjustments are made.
DO NOT use this mount
if
it interferes with the adjustability or the operation
of
your rear view mirror in any way.
DO NOT use this mount
if
the radar detector creates an unsafe viewing obstruction.
DO NOT ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
All Blend Mo Jnt products are accompanied with detailed installation instructions and adjustment tips.
You
are encouraged to contact customerser rice@blend-
mount.com
or
call J28 Design at 1-888-497-8388 for further assistance.
Check the BlendMount Forum for installation tips and some vehicle specific installs. Your feedback is very important to us. Please email any questions
or
www
.
blendmount
.
com
comments you have to customerservlce@blendmount.
com
lnnovati~ De ign
And
Precision Manufacturing
PAGE 2 OF 2
BlendMount - US PATENT# D625,580 S,
0656
,
811
S,
0653
,980 S
and other patents pending