Manualshelf

Owner's Manual

ManualsBrandsBlendMount ManualsGPS & car accessoriesCustom-Fit Radar Detector Mount
12
PART# BRD-2021
Blend
fflaunf-®
Er
ED
OE
1111111111111111111111111111
Innovat
i
ve
Mount
i
ng
Solution
s
LEFT HAND DRIVE VEHICLE
7
28028
41
23
2
INSTALLATION INSTRUCTIONS FOR RADENSO RADAR DETECTORS
Your rear
view
mirror
has minimal clearance between the back side
of
the mirror and the
mirror
stem. It is very important
that this mount is Installed correctly
to
ensure
mirror
adjustabillty
is
retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
NOTE:
For
Illustration
purposes,
the
mount
and
rear view
mirror
shown
in
these
Instructions
may
look
slightly
different
then YOUR
mount
and rear
view
mirror.
RELEASE BUTTON
Before Installing this
mount
on your mirror observe how the spring clip functions. When used properly, the spring clip avoid putting excessive
pressure on the mirror when Installing and removing
th
radar detector (RD).
To
release tension from the spring clip, simply squeeze the tab and
the back side
of
the mount together. This will lower the bottom portion
of
the spring clip allowing you to slide the
RD
on and off the mount. Push the
RD
Release button and slide
th
f.
D onto the
Spring
Clip until you hear it lock into position, then release both the
Tab
and Release Button. Install and
remove the
RD
a few times b ore installing the mount on your mirror. Once the installation is complet , the spring clip allows you to access the
button on top
of
the RD
wh
l still having the RD installed to it as close to the bottom
of
the rear-view mirror
as
possible. By gently pushing
down on the
RD
the spring clip is designed to flex downward allowing you to push desired buttons, then it will spring back into its original position when
you take your finger away.
Th
is can also be usefull to access the release button.
BODY
ASSEMBLY
- /
TOP SECTION
STEP 1 - Loosen the clamp screw so the top section
seperates from the mid section. This will provide the
necessary
clearance to slide the mount over the mirror
stem as shown above. Adju t the
mirror
paralell to
the windshield and slightly upward for ease
of
installation.
PAGE 1 OF 2
TOP AND MID
SECTIONS MUST TOUCH
AT THE PIVOT POINT
BEFORE CLAMP SCREW
IS FULLY TIGHTENED
STEP 2 - BEFORE FULLY TIGHTENING THE
CLAMP SCREW, POSITION THE MOUNT AS FAR
FORWARD TOWARDS THE WINDSHIELD AS YOU
CAN. MAKE SURE THE TOP AND MID SECTIONS
ARE TOUCHING AT THE PIVOT POINT.
If
you can not
get them to touch at the pivot point, you have
an
incom-
patible mi
rror
type
for
this
mount
.

Summary of content (2 pages)