Manualshelf

Owner's Manual

ManualsBrandsBlendMount ManualsGPS & car accessoriesCustom-Fit Radar Detector Mount
12
PART# BRD-2017
Bien
=r
llil
111111111~
I_I
IH
1111
Innovative
Mounting
Solutions
LEFT HAND DRIVE VEHICLE
7
2~02
'-t
~l22
INSTALLATION INSTRUCTIONS FOR RADENSO RADAR DETECTORS
Your rear
view
mirror
has
minimal
clearance between the back side
of
the
mirror
and
the
mirror
stem.
It
is
very
important
that
this
mount
is
installed
correctly
to
ensure
mirror
adjustability
is
retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
NOTE:
for
illustration purposes, the mount and rear view mirror shown in these instructions may look slightly different then YOUR mount
and rear view mirror.
Before installing this mount on your mirror observe how the spring clip functions. When used properly, the spring clip avoids putting excessive
pressure on the mirror when installing and removing the radar detector (RD).
To
release tension from the spring clip, simply squeeze the tab and
the back side
of
the mount together. This will lower the bottom portion
of
the spring clip allowing you
to
slide the RD on and off the mount. Push the RD
Release button and slide the RD onto the Spring Clip until you hear it lock into position, then release both the Tab and Release Button. Install and
remove the RD a few times before installing the mount on your mirror. Once the installation is complete, the spring clip allows you to access the
buttons on top
of
the RD while still having the RD installed to sit as close to the bottom
of
the rear-view mirror as possible. By gently pushing
down on the RD the spring clip is designed to flex downward allowing you to push desired buttons, then it will spring back into its original position when
you take your finger away. This can also be useful! to access the release button.
STEP 1 - Loosen the clamp screw so the top section seperates from
the mid section. This will provi
de
the necessary clearance to slide the
mount over the mirror stem as shown above. Adjust the mirror paralell
to the windshield and slightly upward for ease
of
installation.
TOP AND MID
SECTIONS MUST TOUCH
AT
THE PIVOT POINT
BEFORE CLAMP SCREW
IS FULLY TIGHTENED
STEP 2 - BEFORE FULLY TIGHTENING THE
CLAMP SCREW, MAKE SURE THE TOP AND MID
SECTIONS ARE TOUCHING AT
THE
PIVOT POINT.
If you can not
get
them to touch at the pivot point, you
have an incompatible mirror type
for
this mount.
PAGE 1 OF 2

Summary of content (2 pages)