Owner's Manual
PART# BRD-2000R
Blan
oun
®
Er
d:
-
-
Innovative
Mounting
Solutions
~-·
TOP.CLAMP
fic
REW
• LOWER CLAMPn;,OP
PIVOT SCREW
7 - Install the RD onto the mount. Make the necessary adjustments as
shown above. Using the vertical adjustment, we recommend you
adjust the RD as close to the bottom
of
the mirror as possible. The
spring clip holding the RD is designed to flex downward to allow access
to
the RD buttons as shown below in step 9.
9 -
To
access the buttons
of
the RD you will need to
gently push downward on the front
of
the RD with one
finger and push the desired button with another finger.
Then allow the RD
to
return to it's original position by
gently letting it spring upward. When accessing the
buttons, be sure
to
push the RD downward
just
enough
for your finger
to
fit between the RD and mirror.
Do
not
push down more than what is needed.
8 - At this point your RD should be positioned where you want it and the
screws should be snug. Loosen the top clamp screw so both the lower
clamp/top pivot screws can be fully tightened. Grab the long arm
of
the
allen wrench to assure that these screws are securely tightened, you will
not strip out the tapped holes in the aircraft grade aluminum.
The
bottom clamp screws should be fully tightened before tightening
the top clamp screw.
If
the top screw is tightened before the
bottom screws are, the clamp will loosen over time.
NOTE : This mount can get extremely hot when sitting in direct sunlight. If you
intend
to
remove your RD frequently, you may want to install the two gray "TOUCH
STRIPS" included in the tool kit. Place them where your fingers make contact with
the mount. They may be trimmed with a blade
or
knife.
FOR MORE INFO VISIT www.blendmount.com/videos
CAUTION
DO NOT use this mount
if
it interferes with the adjustability
or
the operation
of
your rear view mirror in any way.
DO NOT use this mount
if
the radar detector creates an unsafe viewing obstruction.
DO NOT ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
All BlendMo Jnt products are accompanied with detailed installation instructions and adjustment tips. You are encouraged to contact customerser 1ice@blend-
mount.com or call J28 Design at 1-888-497-8388 for further assistance.
Check the BlendMount Forum for installation tips and some vehicle specific installs.
www.blendmount.com
Innovative De ign
And
Pr ci ion Manufacturing
PAGE20F
2
Your feedback is very important
to
us. Please email any questions
or
comments you have to customerservlce@blendmount.com
BlendMount - US
PATENT#
0625,580
S, 0656,811 S, D653,980 S
D690,245 S, D690,246
S,
D690,247
Sand
other patents pending