Owner's Manual
PART# BMX-2021
Blend
fflounf-
®
ESCORT
PASSPO
MAX
Innovative
Mount
i
ng
Solutions
5 - Install the
RD
onto the mount. Make the necessary adjustments as shown above.
Using the vertical adjustment, we recommend you adjust the RD so there is approxi-
mately 1/2" gap between the bottom
of
the mirror and the top
of
the RD. After all ad-
justments are made, be sure to check that all adjustment screws are tight. Grab the
long arm
of
the allen wrench to assure that these screws are securely tightened.
You
will not strip out the tapped holes in the aircraft grade aluminum.
6 -
To
access the buttons
of
the RD you will need to gently push
downward on the front
of
the RD with one finger and push the de-
sired button with another finger. Then allow the RD to return to it's
original position by gently letting it spring upward. When accessing
the buttons, be sure to push the RD downward just enough for your
finger to fit between the RD and mirror.
Do
not push down more
than
what
Is needed.
7 - When removing
or
installing the
RD
, squeeze the trigger and the back side
of
the mount together with one hand, and lift the front
of
the RD upward with
the other hand before sliding the RD off
or
onto the spring clip. You
must
lift the front
of
the RD upward before sliding it off
or
onto the mount.
NOTE : This mount can get extremely hot when sitting
in
direct sunlight. If you intend to remove your RD frequently, you may want to install the two gray
"TOUCH STRIPS" included
in
the tool kit. Place them where your fingers make contact with the mount. They may be trimmed with a blade
or
knife.
FOR
MORE INFO VISIT www.blendmount.com/videos
CAUTION
DO
NOT
use this mount
if
it interferes with the adjustability
or
the operation
of
your rear view mirror in any way.
DO
NOT
use this mount if the radar detector creates an unsafe viewing obstruction.
DO
NOT
ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
All BlendM01Jnt products are accompanied with detailed installation instructions and adjustment tips.
You
are encouraged to contact customerser rice@blend-
mount.com
or
call J28 Design at 1-888-497-8388 for further assistance.
Check the BlendMount Forum for installation tips and some vehicle specific installs.
www
.blendmount.com
Innovative Design
And
Precision Manufacturing
PAGE 2 OF 2
Your feedback is very important to us. Please email any questions
or
comments you have to customerservice@blendmount.com
BlendMount- US PATENT# D625,580
S,
D656,
811
S,
D653,980 S
D690,245
S,
D690,246 S, D690,247
Sand
other patents pending