Owner's Manual
PART# BMG-2021
Bland
ffloun
®
ESCORT
Innovative
Mounting
Solutions
5 - While sitting in the passenger seat, place the mount over the mirror
stem.
lighten
the CLAMP SCREW until the mount starts to clamp onto
the mirror stem. Position the mount as far forward as it will go and para-
lell to the bottom
of
the mirror before fully tightening.
PIVOT
ADJUSTMENT
VERTICAL
ADJUSTMENT
--.
~ •
ROTATING
ADJUSTMENT
PIVOT
POINT
TOPANDMID
SECTIONS
MUST
TOUCH
AT THE PIVOT POINT
BEFORE CLAMP SCREW
IS FULLY TIGHTENED
6 • MAKE SURE THE TOP AND MID SECTIONS ARE
TOUCHING AT THE PIVOT POINT. If you can not get them
to touch at the pivot point, you may have an incompatible
mirror type for this mount.
MAGNET
WILL:
RELEASE
7 • Reinstall the body assembly. Be sure to include all
lock washers with screws, and the lock and flat washer
with the bottom socket head screw as shown above. Use
the adjustments shown above to adjust the RD to your
desired position. We recommend adjusting the RD as
close to the bottom
of
mirror as possible. Be sure to tight-
en all screws after adjustments are made.
PUSH
UP
ON FACE AND
TWIST TO REMOVE
8 -
To
remove the radar from the magnetic mount, simply tilt the face
of
the RD up and twist slightly to side, then the magnet will release.
CAUTION
DO NOT use this mount
if
it interferes with the adjustability
or
the operation
of
your rear view mirror in any way.
DO NOT use this mount if the radar detector creates an unsafe viewing obstruction.
DO
NOT
ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
All BlendMo Jnt products are accompanied with detailed installation instructions and adjustment tips.
You
are encouraged to contact customerser ,1ce@blend-
mount.com
or
call J28 Design at 1-888-497-8388 for further assistance.
Check the BlendMount Forum for Installation tips and some vehicle specific Installs. Your feedback is very Important to us. Please email any questions
or
www.blendmount.com comments you have to customerservice@blendmount.com
Innovative Design
And
Precision Manufacturing
PAGE2OF2
BlendMount - US PATENT# D625,580 S, 0656,811 S, 0653,980 S
and other patents pending