Manualshelf

Owner's Manual

ManualsBrandsBlendMount ManualsGPS & car accessoriesBlendMount BMG-2021 Custom-Fit Radar Detector Mount
12
Hien
aunt
®
Innovative
Mounting
Solut
ions
ESCORT
LEFT HAND DRIVE VEHICLE
INSTALLATION INSTRUCTIONS FOR ESCORT IX, REDLINE EX,
AND
360C
RADAR
DETECTORS
Your rear
view
mirror
has
minimal
clearance between the back
side
of
the
mirror
and the
mirror
stem.
It
i
very
important
that
this
mount
is
installed
correctly
to
ensure
mirror
adjustability
is
retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
NOTE:
For illustration purposes,
the
mount
and
rear
view
mirror
shown
in
these instructions
may
look
slightly different
then
YOUR
mount
and
rear
view
mirror.
ALUMINUM
THREADED ---~-w
-.
-~
.-..-.:::;
INSERT
3 - Install aluminum threaded
insert into magnet, and attach
magnet onto blendmount with lip
pointed in direction as shown.
1 - The magnet must be removed from the suction
cup mount that the radar detector came with.
UNSCREW
HERE
TOP
SECTION
2 - Unscrew and remove bolt, only the
magnetic piece is used with the blendmount.
CLEARANCE
FOR
MIRROR
STEM
CLAMP
SCREW
4 - The Body Assembly must be removed to gain access to the CLAMP SCREW.
Remove the two socket head screws as shown above. Be sure to remove the lock
washer with the top screw along with the lock washer and flat washer with the
bottom screw. Loosen the Clamp Screw so there is enough clearance between
the TOP and MID SECTIONS to slide over the mirror stem.
PAGE
1
Of
2

Summary of content (2 pages)