Manualshelf

Owner's Manual

ManualsBrandsBlendMount ManualsGPS & car accessoriesFor use with select Escort detectors with EZ Mag magnetic mounts — fits most vehicles with 1" or longer cylindrical rear-view mirror stem
12
PART# BMG-2000R
Blend
ffluunt
®
ESCORT
llllllll
lllllllllll
11111111111
Innovative
Mounting
Solutions
7
2802
8 4
3645
7
INSTALLATION INSTRUCTIONS FOR
ESCORT
IX RADAR DETECTOR
1 - The magnet must be
removed from the suction
cup mount that the radar
detector came with.
2 - Unscrew and
remove bolt, only the
magnetic piece is used
with the blendmount.
3 - Install aluminum
threaded insert into
magnet, and attach
magnet onto blend-
mount with lip pointed
in direction as shown.
3\4" INNER DIAMETER 7\8" INNER DIAMETER
WITH BUSHINGS WITHOUT BUSHINGS
Grab the mirror and move the stem
upward using the windshield pivot only
Mirror stem can pivot left/right
to
point radar detector where desired
STEM
4 - This mount was designed to fit rear view
mirror stems that are 3/4"
or
7 /8" in diameter.
5 - Most compatible mirrors have a stem between the mirror and the windshield that has a pivot
on both ends. We recommend that you try moving the mirror upward before installing the mount.
If
the mount is too big to clamp onto your
mirror stem, use the two bushings.
Grab the mirror and move the stem upward using the windshield pivot only. Adjust the mirror to
your normal viewing position using the mirror pivot only. Notice the higher location
of
the mirror
as shown above. NOTE: The mirror stem
may
move side
to
side as well. Make sure the
stem points straight ahead
so
the RD does too.
6 - Install the mount while sitting in the passenger side
of
your
vehicle. Remove the right-top portion
of
the mount and position the
mount around the mirror stem as shown above. Reattach the right
side
of
the mount. Make sure the lock washer is still on the lower
clamp screw. Leave the top screw loose so the mount can slide
along the mirror stem and rotate to the desired location. There may
be a plastic oval clip around a wire and the stem, the. clip must be
removed to install the mount. Lightly snug screws,
do
not fully
tighten until last step.
Innovative Design
And
Precision Manufacturing
With center
link installed
BLENDMOUNT
CENTER
LINK
Without center
link installed
7 - The center-link may be removed
if
an overall shorter mount length is needed,
depending on your rear view miror and desired position for the radar detector.
PAGE 1 OF 2
BlendMount - US PATENT# D625,580 S, D656,
811
S, D653,980 S
D690,245 S, D690,246 S, D690,247 S and other patents pending

Summary of content (2 pages)