Owner's Manual
PART# BCB-2130
Blend
llloun-t®
Innovative
Mounting
Solutions
VERTICAL
ADJUSTMENT
5 - Reinstall the
body
assembly. Install the RD onto the mount. Make the necessary
adjustments as shown above.
Using
the
vertical
adjustment,
we
recommend
you
adjust
the
RD
so
there
Is
approximately
1/2"
gap
between
the
bottom
of
the
mirror
and
the
top
of
the RD. After all adjustments are made, be sure to check that
all adjustment screws are tight. Grab the long arm
of
the alien wrench to assure that
these screws are securely tightened. You will not strip out the tapped holes in the
aircraft grade aluminum.
6 -
To
access the buttons
of
the
RD
you
will need to
genUy
push
downward on the front
of
the RD with one finger and push
the
de-
sired button with another finger. Then allow the RD to return to it's
original position by gently letting
it
spring upward. When accessing
the buttons, be sure to push the RD downward just enough for your
finger to fit between the RD and mirror.
Do
not
push
down
more
than
what is needed.
INSTALLING
R ,
SLIDE RD ONTO
. . SPRJNG
~LIP
AS
11,1
AS
ff
'Ill
GO
t
7 • When removing
or
installing the RD, squeeze the trigger and the back side
of
the mount together wi
th
one hand, and lift the front
of
the RD upward with
the other hand before slidi
ng
the
RD off or onto the spring clip.
You
must
lift
the front of the RD upward before sliding It off or onto the
mount.
NOTE : This mount can get extremely hot when sitting
In
direct sunlight.
If
you
intend to remove your RD frequently, you
may
want to install the two gray
"TOUCH STRIPS" included in the tool kit. Place them where your fingers make contact wi
th
the mount. They
may
be trimmed with a blade or knife.
FOR MORE INFO VISIT
www.blendmount.com/vldeos
CAUTION
DO NOT use this mount
if
it interferes with the adjustability or the operation
of
your rear view mirror in any way.
DO NOT use
th
is mount
if
the radar detector creates an unsafe viewing obstruction.
DO NOT ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
All BlendMount products are accompanied with detailed Installation instructions and adjustment
Ups
.
You
are encouraged to contact
customerservlce@blendmount.com
or
call J28 Design
at
1-888-497-8388 for further assistance.
Check the BlendMount Forum for installation tips and some vehicle specific installs.
www.blendmount.com
Innovative Design
And
Precision
Manufacturing
PAGE20F
2
Your feedback Is very important to us. Please email any questions
or
comments you have to cuatomerservlee@blendmount.com
BlendMount - US
PATENT#
0625,580 S, 0656,
811
S, 0653,980 S
0690,245 S, 0690,246 S, 0690.247
Sand
other patents pending