Owner's Manual

PART# BCB-2032
Blan
11111111111111111111111111
Innovative Mounting Solutions
!,cobra
7 28028 46395 8
LEFT HAND DRIVE VEHICLE
INSTALLATION INSTRUCTIONS FOR THE COBRA DSP-9200BT, SPX-7800BTn700, SPX-6700, AND iRAD 900 RADAR DETECTOR
Your rear view mirror has minimal clearance between the back side of the mirror and the mirror stem. It is very important
that this mount is installed correctly to ensure mirror adjustability is retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
NOTE: For illustration purposes, the mount and rear view mirror shown in these instructions may look
slightly different then YOUR mount and rear view mirror.
SQUEEZE --- --
BOTTOM OF SPRING CLIP
IS PARALLEL WITH RD
•
1 - The RELEASE Button on the radar detector (RD) is NOT used with this mount.
2 - The bottom of the spring clip must be parallel with the
top of the RD to slide in and out. SLIDE THE RD ONTO
THE SPRING CLIP AS FAR AS IT WILL GO . Release the
trigger to secure the RD onto the mount. Before installing the
mount onto your rear view mirror, remove and install the RD a
few times so you can observe how the spring clip functions.
To release the tension of the spring clip, simply squeeze the TRIGGER and the back side
of the mount together. This will lower the bottom portion of the spring clip allowing you to
slide the RD on and off. When used properly, the spring clip avoids putting excessive
pressure on the mirror stem when installing and removing the RO . The top portion of
the mount should barely move when the two opposing forces are applied.
CLEARANCE
FOR MIRROR
STEM
3 - The BODY ASSEMBLY must be removed to gain access to the
CLAMP SCREW. Remove the two socket head screws as shown
above. Be sure to remove the lock washer with the top screw along with
the lock washer and flat washer with the bottom screw. Loosen the
CLAMP SCREW so there Is enough clearance between the TOP and
MID SECTIONS to slide over the mirror stem.
Innovative D lgn And
Precision Manufacturing
ROTATING
ADJUSTMENT
SCREW
TOP AND MID
SECTIONS MUST TOUCH
AT THE PIVOT POINT
BEFORE CLAMP SCREW
IS FULLY TIGHTENED
4 - While sitting in the passenger seat, place the mount over the mirror
stem . Tighten the CLAMP SCREW until the mount starts to clamp onto the
mirror stem . As you are tightening the clamp screw, MAKE SURE THE TOP
AND MID SECTIONS TOUCH AT THE PIVOT POINT. If they do not touch
at the pivot point. YOU HAVE AN INCOMPATIBLE MIRROR TYPE FOR
THIS MOUNT . Position the mount as far forward as it will go and parallel to
the bottom of the mirror before fully tightening.
PAGE 1 OF 2
BlendMount • US PATENT# 0625,580 S, 0656,811 S, D653 , 980 S
0690, 245 S, D690 , 246 S, 0690,24 7 S and other patents pending