Owner's Manual
PART# BCB-2027
Blend
ffloun
®
Innovative
Mounting
Solutions
CLAMP SCREW
CLAMP
SCREW MUST
BE
SLIGHTLY LOOSENED
BEFORE
MAKING
ROTATING ADJUSTMENT
BE SURE TO RETIGHTEN
AFTER ADJUSTMENT IS
MADE
ROTA
T
ING
ADJUSTMENT
DRIVER'S PERSPECTIVE
WITH
NO
ROTATING
ADJUSTMENT
USED
&cobra
·
DRIVER'S
PERSPECTIVE
WITH
RADAR
ROTATED
TOWARDS
DRIVER
STEP
3 • Install your radar detector onto the mount. Use the adjustments shown above to adjust the
RO
to your desired position. We recom-
mend adjusting the
RO
as close to the bottom
of
your mirror as you can. NOTE When the rotating adjustment is used to rotate the
RD
towards
the driver, the footprint of the RD
is
reduced as shown above. Be sure to tighten all
of
the adjustment screws after the adjustments are made.
STEP
4 • With the RD adjusted right below the mirror
as
recommended, you will probably not be able to get your fingers between the
RD
and mirror to
access the buttons. The
spring
clip
allows
you
to
pus
h
the
front
of
the
RD
downward
with
one
finger
and
press
the
buttons
with
another
finger
as shown above (Escort brand radar detector shown).
NOTE : This mount can get extremely hot when sitting
in
direct sunlight. If you intend to remove your RD frequenUy, you may want to install the two gray
"TOUCH STRIPS" included in the tool kit. Place them where your fingers make contact wi
th
the mount. They may be trimmed with a blade
or
knife.
FOR
MORE
INFO
VISIT
www.blendmount.comMdeoa
CAUTION
DO NOT use this mount
if it
interferes with the adjustability
or
the operation of your rear view mirror in any way.
DO NOT use this mount if the radar detector creates
an
unsafe viewing obstruction.
00
NOT ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
All BlendMount products are accompanied with detailed Installation instructions and adjustment tips.
You
are encouraged to contact
customerservice@blendmounl.com
or
call J28 Design at 1-888-497-8388 for further assistance.
Check the BlendMount Forum for Installation lips and some vehicle specific Installs.
www.bfendmount.com
Innovative Design
And
Precision Manufacturing
PAGE20F2
Your feedback
ts
very Important to us. Please email any questions
or
comments you have to customernn1lce@blendmounLcom
BlendMount - US PATENT# D625,580 S, D656,
811
S,
0653
,980 S
0690
,245 S, D690,246
S,
D690,247
Sand
other patents pending