Owner's Manual
PART# BCB-2025
Bien
aunt-®
Innovative
Mounting
Solutions
PIVOT
ADJUSTMENT
5 - Reinstall the body assembly. Install the RD onto the mount. Make the necessary
adjustments as shown above. Using the vertical adjustment, we recommend you
adjust the RD so there is approximately 1/2" gap between the bottom of the
mirror and the top of the RD. After all adjustments are made, be sure to check that
all adjustment screws are tight. Grab the long arm
of
the alien wrench to assure that
these screws are securely tightened.
You
will not strip out the tapped holes
in
the
aircraft grade aluminum.
6 -
To
access the buttons
of
the RD you will need to gently push
downward on the front
of
the RD with one finger and push the de-
sired button with another finger. Then allow the
RD
to return to it's
original position by gently letting it spring upward. When accessing
the buttons, be sure to push the RD downward just enough for your
finger to fit between the RD and mirror. Do not push down more
than what Is needed.
;,:
iNSTALLING R '
. - ....
SLIDE
RC)
ONTO
c-,.
- ,
· • SPRING CLIP AS
_,
AS
IT
'LL
GO
'
7 - When removing or installing the RD, squeeze the trigger and the back side
of
the mount together with one hand, and lift the front
of
the
RD
upward with
the other hand before sliding the RD
off
or
onto the spring clip. You
must
11ft
the
front
of
the
RD
upward
before
slldlng
It
off
or
onto
the
mount.
NOTE : This mount can get extremely hot when sitting in direct sunlight. If you intend to remove your RD frequently, you may want to install the two gray
"TOUCH STRIPS" included in the tool kit. Place them where your fingers make contact with the mount. They may be trimmed with a blade or knife.
FOR MORE INFO VISIT www.blendmount.com/videos
CAUTION
DO NOT use this mount If it interferes with the adjustability or the operation
of
your rear view mirror
in
any way.
DO NOT use this mount if the radar detector creates
an
unsafe viewing obstruction.
DO NOT ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
All BlendMoJnt products are accompanied with detailed installation instructions and adjustment tips.
You
are encouraged to contact customerser
•i
ce@blend-
mount.com
or
call J28 Design at 1-888-497-8388 for further assistance.
Check the BlendMount Forum for Installation tips and some vehicle specific installs.
www.blendmount.com
Innovative Design
And
Precision Manufacturing
PAGE2
OF 2
Your feedback Is very Important to us. Please email any questions or
comments you have to customerservlce@blendmount.com
BlendMount - US PATENT# D625,580 S, D656,
811
S, D653,980 S
D690,245
S,
D690,246 S, D690,247
Sand
other patents pending