Owner's Manual
PART# BCB-2021
Blan
moun
&cobra
Innovative
Mounting
Solutions
ROTATING
ADJUSTMENT
5 • Install the RD onto the mount. Make the necessary adjustments as shown above.
Using the vertical adjustment, we recommend you adjust the RD so there is approxi-
mately 1/2" gap between the bottom
of
the mirror and the top
of
the RD. After all ad-
justments are made, be sure to check that all adjustment screws are tight. Grab the
long arm
of
the allen wrench to assure that these screws are securely tightened.
You
will not strip out the tapped holes
In
the aircraft grade aluminum.
6 •
To
access the buttons
of
the RD you will need to gently push
downward on the front
of
the RD with one finger and push the de-
sired button with another finger. Then allow the RD to return to it's
original position
by
gently letting it spring upward. When accessing
the buttons, be sure to push the RD downward just enough for your
finger to fit between the RD and mirror. Do not pu h down more
than what Is n ded.
7 • When removing
or
installing the RD, squeeze the trigger and the back side
of
the mount together with one hand, and lift the front
of
the RD upward with
the other hand before sliding the RD
off
or
onto the spring clip.
You
must
11ft
the front of the
RD
upw
rd
b fore slldlng It off or onto the mount.
NOTE : This mount can get extremely hot when sitting
In
direct sunlight. If you intend to remove your RD frequently, you may want to install the two gray
"TOUCH STRIPS" included in the tool kit. Place them where your fingers make contact with the mount. They may be trimmed with a blade
or
knife.
FOR MORE INFO VISIT www.blendmount.com/vld o
CAUTION
DO NOT use this mount if it interferes with the adjustability or the operation
of
your rear
view
mirror in any way.
DO
NOT use this mount
if
the radar detector creates an unsafe viewing obstruction.
DO
NOT
ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for
ass
i
stance
.
All BlendMo Jnt products are accompanied with detailed installation instructions and adjustment tip . You are encouraged to contact customerser
,1ce@bl
nd-
mount.com
or
call J28 Design at 1-888-497 -8388 for further assistance.
Check the BlendMount Forum
for
Installation tips and some vehicle specific Installs.
www.blendmount.com
Innovative D sign
And
Pr,
clsion Manufacturing
PAGE 2 OF 2
Your feedback
Is
very Important to us. Please email any question or
comments you have
to
cu
tom
rs
rvlc
bl
ndmount.eom
BlendMount • US
PATENT#
D625,580 S,
0656
,
811
S,
0653
,980 S
D690,245 S,
0690
,246 S, D690,247
Sand
other patents pending