Manualshelf

Owner's Manual

ManualsBrandsBlendMount ManualsGPS & car accessoriesCustom-Fit Radar Detector Mount
12
PART# BCB-2017
111111111~1111111~
111
f-®
----------------
Blend
fflou:
Innovat
i
ve
Mount
i
ng
So
l
ut
i
on
s
&,cobra
·
28028
1105
8
LEFT HAND DRIVE VEHICLE
INSTALLATION INSTRUCTIONS FOR THE
COBRA
DSP-9200BT,
SPX-7800BTn700
, SPX-6700,
AND iRAD
900
RADAR
DETECTOR
Your rear view
mirror
has minimal clearance between the back side
of
the
mirror
and the
mirror
stem.
It
is
very important that
this
mount
is installed correctly
to
ensure
mirror
adjustability
is
retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
NOTE: For illustration purposes, the mount and rear view mirror shown in these instructions may look slightly different then YOUR
mount and rear view mirror.
BEFORE INSTALLING THIS MOUNT ON YOUR MIRROR observe how the spring clip functions. When used properly, the spring clip avoid putting
exce slve pressure on the mirror when Installing and moving the radar detector (RD).
To
release tension from the spring clip, simply squeeze the
tab and the back side
of
the mount together. This will lower the bottom portion
of
the spring clip allowing you to slide the RD on and off the mount. Push
the RD Release button and slide the RD onto the Spring Clip as far as it will
go
. Then release both the Tab and the Release Button. Slide the RD toward
you just slightly until you hear it lock into position. Install and remove the RD a few times before installing the mount on your mirror.
TOP SECTION
STEP 1 • Loosen the clamp screw so the top section seperates from
the mid section. This will provide the necessary clearance to slide the
mount over the mirror stem
as
shown above. Adjust the mirror paralell
to th wlndshl Id and slightly upward for ease
of
Installation.
TOP AND MID
SECTIONS MUST TOUCH
AT
THE PIVOT POINT
BEFORE CLAMP SCREW
IS FULLY TIGHTENED
STEP 2 • BEFORE FULLY TIGHTENING THE CLAMP
SCREW, MAKE SURE THE TOP AND MID SECTIONS
ARE TOUCHING AT THE PIVOT POINT.
If
you can not get
them to touch at the pivot point, you have an Incompatible
mirror type for this mount.
PAGE 1
OF2
PIVOT
POINT

Summary of content (2 pages)