Owner's Manual
PART# BBE-3030
Blend
fflaunt-®
ESCORT
rRO
JCS
Innovative
Mounting
Solutions
STEP 3 • While sitting in the passenger seat, place the mount over
the mirror stem. Tighten the CLAMP SCREW until the mount starts to
clamp onto the mirror stem. Position the mount as far forward as it will
go and paralell to the bottom
of
the mirror before fully tightening.
PIVOT
POINT
TOP AND MID
SECTIONS
MUST
TOUCH
AT THE PIVOT POINT
BEFORE CLAMP SCREW
IS FULLY TIGHTENED
STEP 4 • MAKE SURE THE TOP AND MID SECTIONS
ARE TOUCHING AT
THE
PIVOT POINT. If you can not get
them to touch at the pivot point, you have an incompatible
mirror type
for
this mount.
PIVOT
ADJUSTMENT
STEP 5 - Reinstall the BODY ASSEMBLY. Be sure to include the
lock washer with the top socket head screw and the lock and flat
washer with the bottom socket head screw as shown above. NOTE:
there are extra lock and flat washers included
in
the tool kit just
in
case you happen to misplace one.
VERTICAL
ADJUSTMENT
STEP 6 - Install your radar detector onto the mount. Use the ad-
justments shown above to adjust the RD to your desired position.
We recommend adjusting the RD as close to the bottom
of
your
mirror as you can. Be sure to tighten all adjustment screws after the
adjustments are made.
CAUTION
DO
NOT
use this mount
if
it interferes with the adjustability or the operation
of
your rear view mirror
in
any way.
DO
NOT use this mount
if
the radar detector creates an unsafe viewing obstruction.
DO
NOT ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
All BlendMo,Jnt products are accompanied with detailed installation instructions and adjustment tips.
You
are encouraged to contact customerser ,ice@blend-
mount.com
or
call J28 Design at 1-888-497-8388 for further assistance.
Check the BlendMount Forum for installation tips and some vehicle specific installs.
www
.blendmount.com
Innovative Design And
Precision Manufacturing
PAGE 2 OF 2
Your feedback is very important to us. Please email any questions or
comments you have to customerservice@blendmount.com
BlendMount - US
PATENT#
D625,580
S,
D656,
811
S, D653,980 S
D690,245 S, D690,246 S,
0690
,247
Sand
other patents pending