Owner's Manual

PART# BBE-2027
Blend fflaunt ®
ESCORT
1RO ICS
111111111111111m1 ill
Innovative Mount i ng Solutions LEFT HAND DRIVE VEHICLE
.,, 28028 32194 4
INSTALLATION INSTRUCTIONS FOR BELTRONICS AND ESCORT RADAR DETECTORS
Your rear view mirror has minimal clearance between the back side of the mirror and the mirror stem. It is very imp ortant
that this mount is installed correctly to ensure mirror adjustability is retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
RELEASE BUTTON
BEFORE INSTALLING THIS MOUNT ON YOUR MIRROR observe how the spring clip functions. When used properly, the spring clip avoids putting
excessive pressure on the mirror when installing and removing the radar detector (RD). To release tension from the spring clip, simply squeeze the
tab and the back side of the mount together. This will lower the bottom portion of the spring clip allowing you to slide the RD on and off the mount. Push
the RD Release button and slide the RD onto the Spring Clip as far as it will go. Then release both the Tab and the Release Button. Slide the RD toward
you just slightly until you hear it lock into position. Install and remove the RD a few times before installing the mount on your mirror.
TOP
SECTION
STEP 1 - Loosen the clamp screw so the top section separates
from the mid section. This will provide the necessary clearance to
slide the mount over the mirror stem as shown above.
Innovative Design And
Precision Manufacturing
STEP 2 - Tighten the clamp screw until the Top and Mid Sections are slight•
ly snug around the mirror stem. You should still be able to move the mount
3Iong the stem. Before fully tightening the clamp screw, slide the mount towards
the windshield as far as it will go. There should be approximately 1/8" between
the back of the mirror and the mount as shown above.
PAGE 1 OF 2
BlendMount- US PATENT# 0625,580 S, 0656 , 811 S, 0653,980 S
0690,245 S, 0690,246 S, 0690 ,247 Sand other patents pending