Owner's Manual
PART# BBE-2021
Blend
fflaun
®
TRONICS
Innovative
Mount,ng
Solutions
STEP 3 - W
hen
the mount
is
positioned
as
far forr-
ward
as
it will
go,
tighten the clamp screw untill the
Top
and
Mid
Sections are slightly snug around the mirror
stem.
You
should still
be
able to rotate the mount.
STEP 4 - Rotate the mount
so
it is parallel with the
bottom of the mirror. Tighten the clamp screw until! the
mount
is
securely attached
to
the mirror stem.
ROTATING
ADJUSTMENT
CLAMP SCREW MUST
BE SLIGHTLY LOOSENED
BEFORE MAKING
ROTATING ADJUSTMENT
BE SURE TO RETIGHTEN
AFTER ADJUSTMENT IS MADE
STEP 5 - Install your radar detector onto the mount.
Use
the adjustments shown above to adjust the
RD
to your desired position.
We
recommend adjusting the
RD
as close
to
the bottom of your mirror
as
you
can.
Be
sure to tighten all adjustment screws after the adjust-
ments
are
made. For the Pivot adjustment, grab the long
arm
of the allen wrench for maximum leverage.
You
will not strip the threaded
holes
in
the aircraft grade aluminum.
CAUTION
DO
NOT use this mount if it interferes with the adjustability or the operation of your rear view mirror
in
any
way.
DO
NOT
use
this mount if the radar detector creates
an
unsafe viewing obstruction.
DO
NOT
ATTEMPT
TO
MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
All
BlendMo Jnt products are accompanied with detailed installation instructions
and
adjustment tips.
You
are encouraged
to
contact customerser
1ice@blend-
mount.com or call J28 Design at 1-888-497-8388 for further assistance.
Check the BlendMount Forum for installation tips
and
some vehicle specific installs.
Your
feedback
is
very important to
us.
Please email any questions or
www.blendmount.com comments
you
have to customerservice@blendmount.com
Innovative Design
And
Precision Manufacturing
PAGE 2 OF 2
BlendMount -
US
PATENT# D625,580
S,
D656,811
S,
D653,980 S
and
other patents pending