Manualshelf

Owner's Manual

ManualsBrandsBlendMount ManualsGPS & car accessoriesCustom-Fit Radar Detector Mount
12
PART# BBE-2021
Hlend
fflounf-®
ESCORT.
'FRO
IC
11
11111
m
11
111
1
Innovative
Mounting
Solutions
LEFT HAND DRIVE VEHICLE
28028
23382
7
INSTALLATION INSTRUCTIONS FOR BELTRONICS AND ESCORT RADAR DETECTORS
Your rear view
mirror
has minimal clearance between the back side
of
the
mirror
and the
mirror
stem.
It
is
very important
that
this
mount
is installed correctly
to
ensure
mirror
adjustability is retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
NOTE: For illustration purposes, the mount and rear view mirror shown In these Instructions may look slightly different then YOUR
mount and rear view mirror.
RELEASE BUTTON
Before installing this mount on your mirror observe how the spring clip functions. When used properly, the spring clip avoids putting excessive
pre sure on the mirror when installing and removing the radar detector (RD).
To
release tension from the spring clip, simply squeeze the tab and
the back side
of
the mount together~ This will lower the bottom portion
of
the spring clip allowing you to slide the RD on and off the mount. Push the RD
Release button and slide the RD onto the Spring Clip until you hear it lock into position, then release both the
Tab
and Release Button. Install and
remove the RD a few times before installing the mount on your mirror. Once the installation is complete, the spring clip allows you to access the
buttons on top
of
the RD while still having the RD installed to sit as close to the bottom
of
the rear-view mirror as possible. By gently pushing
down on the
RD
the spring clip is designed to flex downward allowing you to push desired buttons, then it will spring back into its original position when
you take your finger away. This can also be useful! to access the release button.
BODY
ASSEMBLY
TOP SECTION
MIDSECTION
STEP 1 • Loosen the clamp screw so the top section seper-
ates from the mid section. This will provide the necessary clear-
ance to slide the mount over the mirror stem as shown above.
Adju t th mirror paralell to the windshield and slightly
upward for ease
of
installation.
PAGE 1
OF2
TOP AND MID
SECTIONS MUST TOUCH
AT THE PIVOT POINT
BEFORE CLAMP SCREW
IS FULLY TIGHTENED
STEP 2 • BEFORE FULLY TIGHTENING THE CL.AMP
SCREW, POSITION THE MOUNT
AS
FAR FORWARD TO-
WARDS THE WINDSHIELD
AS
YOU CAN.
MAKE
SURE THE
TOP AND MID SECTIONS ARE TOUCHING AT THE PIVOT
POINT. If you can not get them to touch at the pivot point, you
have an
incompatible
mirror
type
for
this
mount
.

Summary of content (2 pages)