Owner's Manual
PART# BBE-2000R
Hlend
fflounf-
®
ESCORT
1RONIC
Innovative
Mounting
Solutions
7 - Install the RD onto the mount. Make the necessary adjustments as
shown above. Using the vertical adjustment, we recommend you
adjust the RD as close to the bottom
of
the mirror as possible. The
spring clip holding the RD is designed to flex downward to allow access
to the RD buttons as shown below in step 9.
9 -
To
access the buttons
of
the RD you will need to gently push
downward on the front
of
the RD with one finger and push the
desired button with another finger. Then allow the RD to return
to it's original position by gently letting it spring upward. When
accessing the buttons, be sure to push the RD downward just
enough for your
fi
nger to fit between the
RD
and mirror. Do not
push down more than what is needed.
TOP CLAMP
SCREW
TIGHTEN LAST!!!
8 - At this point your RD should be positioned where you want it and the
screws should be snug. Loosen the top clamp screw so both the lower
clamp/top pivot screws can be fully tightened. Grab the long arm
of
the
alien wrench to assure that these screws are securely tightened, you will
not strip out the tapped holes in the aircraft grade aluminum. The
bottom clamp screws should be fully tightened before tightening
the top clamp screw.
If
the top
screw
is tightened before the
bottom screws are, the clamp will loosen over time.
NOTE : This mount can get extremely hot when sitting in direct sunlight.
If
you
intend to remove your RD frequently, you may want to install the two gray
"TOUCH STRIPS" included in the tool kit. Place them where your fingers make
contact with the mount. They may be trimmed with a blade
or
knife.
FOR
MORE INFO VISIT www.blendmount.com/videos
CAUTION
DO
NOT
use this mount if it interferes with the adjustability or the operation
of
your rear view mirror in any way.
DO
NOT
use this mount
if
the radar detector creates an unsafe viewing obstruction.
DO
NOT
ATTEMPT TO MODIFY THIS PRODUCT. Consult the manufacturer for assistance.
All BlendMount products are accompanied with detailed installation instructions and adjustment tips. You are encouraged to contact
customerservice@blendmount.com
or
call J28 Design at 1-888-497-8388 for further assistance.
Check the BlendMount Forum for installation tips and some vehicle specific installs.
www.blendmount.com
Innovative Design
And
Precision Manufacturing
PAGE 2
OF
2
Your feedback is very important to us. Please email any questions or
comments you have to customerservice@blendmount.com
BlendMount - US PATENT# D625,580 S, D656,
811
S, D653,980 S
D690,245 S, D690,246 S,
0690
,247
Sand
other patents pending