User Guide

Blaze Outdoor Products Instructional Book
Page | 16
placing the burner tube shutter hole securely over the valve orifice and ensuring the male post on the griddle
chassis rests in the corresponding slot in the rear of the burner. Failure to do so could result in a fire and injury.
Never place your fingers inside the observation openings in the griddle plate during
removal or replacement of the griddle plate as they could be pinched. Never place your
fingers inside the observation openings in the griddle at any time as injury could occur.
Gas Connections
Natural Gas Requirements
 Connect a suitable natural gas flex connector to the griddle regulator located on the rear right corner of the
appliance. It is recommended to use a flex connector with a minimum of a ½” diameter or larger.
 Sealing all non-flared fittings with thread sealant or Teflon tape.
 Ensure the flex connector is protected from sharp edges, heat, aggressive surfaces, and kinking.
 Check the appliance controls to ensure all control valves are in the full OFF position.
 Turn on the main gas supply and check all connections for leaks using soapy water as described in the leak
testing procedure section.
 The regulator used must be set for 4” water column and is for use with Natural gas only. Note: Most low
pressure regulators have a directional arrow indicating the direction in which the gas must travel. Ensure
the arrow is pointing in the direction of the griddle.
 An installer supplied gas shutoff valve must be installed in an accessible place.
Liquid Propane (LP) Gas and Tank Requirements
 If your BLAZE GRIDDLE is for Liquid Propane application, a L.P regulator set for 11” WC must be used and is
for use with L.P. gas only.
 The regulator and hose supplied must be used with a 20 lb. L.P. cylinder.
 A collar to protect the cylinder threads on the customer supplied tank.
 An arrangement for gas vapor withdrawal.
 A safety relief device having direct communication with the vapor space of the cylinder.
 A method of mounting.
 The gas supply must be turned off at the LP Gas supply cylinder and the LP Gas supply cylinder must be
disconnected from the regulator when this outdoor cooking gas appliance is not in use.
 Always sit the cylinder in an upright position so that the cylinder valve is at the top. This will ensure proper