User Guide
Table Of Contents
- USE & CARE GUIDE
- ATTENTION:
- I. Safety and Installation Warnings 4-7
- II. Location of Appliance 8-9
- i. Electrical Safety and Installation Warnings 10-11
- III. Gas Safety and Installation Warnings 11-12
- IV. Gas Leaks 13
- i. Checking for Gas Leaks 13-15
- ii. Unpacking Unit 15-16
- V. Gas Connections 16
- i. Natural Gas Requirements 16
- ii. Liquid Propane Gas and Tank Requirements 16-18
- iii. Transporting and Storing LP Gas 17-18
- VI. Installing the Appliance in an Island 19-22
- i. Outdoor Kitchen Ventilation 20-21
- ii. Building Specifications + Instruction 21-23
- iii. Installation Diagrams 23-24
- VII. First Time Operation 25
- i. Lighting the Appliance 25-26
- ii. Manually Lighting the Appliance 26-27
- iii. Flame Adjustment 27
- VIII. Cleaning your Appliance 28-29
- IX. Fuel Conversion 30-32
- Do not attempt to heat unopened containers on the griddle as pressure may build up and cause the container to explode.
- Never use charcoal or any other solid fuel in the griddle.
- Never cook without the drip pan in place.
- Never operate this griddle while under the influence of alcohol or drugs.
- Never place your fingers inside the observation openings in the griddle plate during removal or replacement of the griddle plate as they could be pinched. Never place your fingers inside the observation openings in the griddle at any time as injury co...
- Location of Appliance
- Gas Safety and Installation Warnings
- IMPORTANT: Never connect the appliance to an unregulated gas supply.
- Installation must conform with local codes or in the absence of local codes, to the National Fuel Gas Code, ANSI Z223.1/NFPA 54 and Natural Gas Installation Code, CSA B149.1. All Natural Gas installations must conform to local codes or in the absence ...
- Leak Testing
- NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS.
- Never place your fingers inside the observation openings in the griddle plate during removal or replacement of the griddle plate as they could be pinched. Never place your fingers inside the observation openings in the griddle at any time as injury co...
- Never place your fingers inside the observation openings in the griddle plate during removal or replacement of the griddle plate as they could be pinched. Never place your fingers inside the observation openings in the griddle at any time as injury co...
- Natural Gas Requirements
- Liquid Propane (LP) Gas and Tank Requirements
- Installing the Appliance in a BBQ Island
- FIRST-TIME OPERATION
- Cleaning Your Appliance
- Fuel Conversion
- Warranty Registration
- Improper Maintenance, high cooking temperatures, excessive humidity, chlorine, fertilizers, lawn pesticides, chemicals, and salt can affect the Stainless Steel components and for these reasons, the warranties DO NOT COVER DISCOLORATION, SURFACE RUST, ...
- Locating the Product Serial Number:
- Blaze Product Registration
- Blaze Outdoor Products, Warranty Registration, 6620 Greenwell Springs Rd.
- Baton Rouge, LA 70805
Blaze Outdoor Products Instructional Book
Page | 10
Electrical Safety and Installation Warnings
Extension cords may be used if care is exercised in their use.
If
an extension cord is used:
The marked electrical rating of the cord set or extension cord should be at least as great as the electrical
rating of the appliance
The cord should be arranged so that it will not touch hot surfaces, sharp edges or drape over the
countertop or tabletop (where it can be pulled or tripped over unintentionally).
Outdoor extension cords should be used with products suited for outdoor use. They are surface marked with
suffix letters "W" or "W-A" and with a tag stating "Suitable for Use with Outdoor Appliances".
To protect against electrical shock, the power cord and plug should be kept dry and off of the ground.
Do
not clean this product with water spray; do not spray cleaners into the lamp socket area.
Gasoline, lighter fluid or other flammable liquids and vapors should never be stored in the area of this appliance
or any other appliance.
Before installation or service, disconnect the power supply to the work area by removing the fuse, "tripping" the
circuit breaker, or unplugging the unit.
NOTE: Use a 15 AMP Breaker with GFI protection.
NOTE: This griddle uses a “Transformer” to provide power to the LED lights and internal lights. This
diagram shows the connection to the transformer.
Keep any electrical supply cord and fuel supply hose away from any heated surfaces, sharp edges and
dripping
grease.
Do not operate any appliance with a damaged power cord or power plug, and do not operate any appliance after
the appliance malfunctions or has been damaged in any manner. If this should occur, return the appliance to
the
nearest authorized service facility for examination, repair or adjustment.
This appliance conforms to all uniform electrical safety codes and electrical grounding regulations. Install
unit
according to I.A.W. local codes or with National Electrical Code ANSI/NFPA 70 or CSA C22.1 in their
absence.