Owner's Manual
Table Of Contents
- USE & CARE GUIDE
- ATTENTION:
- I. Safety and Installation Warnings 4-7
- II. Location of Appliance 8-9
- i. Electrical Safety and Installation Warnings 10-11
- III. Gas Safety and Installation Warnings 11-12
- IV. Gas Leaks 13
- i. Checking for Gas Leaks 13-15
- ii. Unpacking Unit 15-16
- V. Gas Connections 16
- i. Natural Gas Requirements 16
- ii. Liquid Propane Gas and Tank Requirements 16-18
- iii. Transporting and Storing LP Gas 17-18
- VI. Installing the Appliance in an Island 19-22
- i. Outdoor Kitchen Ventilation 20-21
- ii. Building Specifications + Instruction 21-23
- iii. Installation Diagrams 23-24
- VII. First Time Operation 25
- i. Lighting the Appliance 25-26
- ii. Manually Lighting the Appliance 26-27
- iii. Flame Adjustment 27
- VIII. Cleaning your Appliance 28-29
- IX. Fuel Conversion 30-32
- Do not attempt to heat unopened containers on the griddle as pressure may build up and cause the container to explode.
- Never use charcoal or any other solid fuel in the griddle.
- Never cook without the drip pan in place.
- Never operate this griddle while under the influence of alcohol or drugs.
- Never place your fingers inside the observation openings in the griddle plate during removal or replacement of the griddle plate as they could be pinched. Never place your fingers inside the observation openings in the griddle at any time as injury co...
- Location of Appliance
- Gas Safety and Installation Warnings
- IMPORTANT: Never connect the appliance to an unregulated gas supply.
- Installation must conform with local codes or in the absence of local codes, to the National Fuel Gas Code, ANSI Z223.1/NFPA 54 and Natural Gas Installation Code, CSA B149.1. All Natural Gas installations must conform to local codes or in the absence ...
- Leak Testing
- NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS.
- Never place your fingers inside the observation openings in the griddle plate during removal or replacement of the griddle plate as they could be pinched. Never place your fingers inside the observation openings in the griddle at any time as injury co...
- Never place your fingers inside the observation openings in the griddle plate during removal or replacement of the griddle plate as they could be pinched. Never place your fingers inside the observation openings in the griddle at any time as injury co...
- Natural Gas Requirements
- Liquid Propane (LP) Gas and Tank Requirements
- Installing the Appliance in a BBQ Island
- FIRST-TIME OPERATION
- Cleaning Your Appliance
- Fuel Conversion
- Warranty Registration
- Improper Maintenance, high cooking temperatures, excessive humidity, chlorine, fertilizers, lawn pesticides, chemicals, and salt can affect the Stainless Steel components and for these reasons, the warranties DO NOT COVER DISCOLORATION, SURFACE RUST, ...
- Locating the Product Serial Number:
- Blaze Product Registration
- Blaze Outdoor Products, Warranty Registration, 6620 Greenwell Springs Rd.
- Baton Rouge, LA 70805
Blaze Outdoor Products Instructional Book
Page | 25
FIRST-TIME OPERATION
Caution: Never operate the appliance unattended. The surface is extremely hot and someone can touch the hot
surface and get seriously burned. All gas appliances should be attended at all times.
Prior to using your appliance, verify that all of the following is correct:
The burner tubes are free of any debris or obstruction.
Installation of the proper gas type and regulator settings.
The proper gas connection is complete.
Check for gas leaks.
Minimum clearances are maintained.
All packaging has been removed.
All parts and components are properly in place.
An installer-supplied manual gas shut-off valve is fully accessible.
Gas hoses are clean and inspected for cuts, wear, abrasion, or leaks. Replace if necessary with a
suitable
UL, ETL or CSA Listed part with internally threaded connector.
Lighting the Appliance
1.
Remove the Protective Stainless cover from the Griddle Plate
2.
Use caution when lighting burners by standing as far away from the burners as possible. Do not put
your hands, arms, head or any body parts close to the griddle when lighting.
3.
To ignite burners, push the burner knob in and slowly rotate counter-clockwise to the high position.
4.
You will hear a loud click as the electronic lighter produces a spark. Listen for the sound of the gas
igniting
and look for a flame through the circular openings in the front of the griddle plate. If the burner
does not light on the first try, repeat
immediately
5.
If the burner does not light in 5 seconds, turn the burners off and wait five minutes until the gas clears