Manual

7
ICE MAKER INSTALLATION
Unpacking
Remove packaging materials.
IMPORTANT: Do not remove any permanent instruction labels or the data
label on your ice maker.
Remove tape and glue from your ice maker before using.
• To remove any remaining tape or glue. Tape or glue residue can also be easily
removed by rubbing a small amount of liquid dish soap over the adhesive with
your fingers. Wipe with warm water in the direction of stainless steel grain.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue. These products can damage the surface of
your ice maker.
Cleaning before use
After you remove all of the packaging materials, clean the inside of your ice maker
before using it. See the "Interior cleaning" in the Cleaning and Maintenance
section.
Location requirements
INSTALLATION CLEARANCES:
Excessive Weight Hazard
Use two or more people to move and install ice maker. Failure to do so
can result in back or other injury.
SIDE VIEW
TOP VIEW
Top of unit
Rear of unit
Front of unit
Side Side
4”
1”
1”
1”