Manual

25
Water is leaking out
of the unit.
Some water falls to the floor
when you open the door to
remove ice from storage bin.
Normal condensation on the door or some
water together with ice. Take care when you
take out ice.
Water supply connection is
leaking.
Tighten fitting. See Connecting the water line.
Drain pipe higher than drain
outlet.
Lower drain pipe.
Cubes are partially
formed or are white
on the bottom.
Not enough water in the water
trough.
Check if the water supply pressure is below 15
psig.
Check water supply or filter may be restricted.
Check for a water leak at the water trough.
Noise during
operation.
The feet are not leveled and
locked.
Level and lock the feet. See Leveling the Ice
Maker.
Certain sounds are normal.
See Normal Sounds.
The ice maker stops
suddenly while
making ice.
The electricity is off.
Reconnect the power supply line.
The environment temperature
is out of the stated range.
Cut off the electricity and leave the ice maker
disconnected until the temperature returns to
within the stated range.
The ice storage bin is full of
ice.
Remove some ice cubes; make sure the
ice-full probe is free of ice.
The body of the ice
maker is electrified.
The ground line isn't in the
socket.
Use a socket meeting the grounding
requirements.
Scaling occurs
frequently inside the
machine.
The hardness level of the
water is too high.
Install a water-softening device in front of the
water inlet.
Water leaks from the
ice storage bin.
The drainhole below the ice
storage bin is blocked.
Remove the ice storage bin and clean the
drainhole.
The drain hose is kinked or
improperly placed higher than
the floor of the ice storage bin.
Check the drain hose to be sure water can be
drained out unhindered.