Manual

24
MAJOR FUNCTIONS
1. The operating procedure is completely automatic.
2. When the ice storage bin is full of ice cubes, the machine stops making ice
automatically. It starts making ice again after ice cubes are removed.
3. The different colors of the LED display indicate various work modes.
4. A sensitive probe and accurate timer enhance the performance of the ice
maker.
5. A compressor protection system is built in.
TROUBLESHOOTING
Before Calling for Service
If the unit appears to be malfunctioning, read through the OPERATION section of
this manual first. If the problem persists, check the Troubleshooting Guide on the
following pages. Some of the problems mentioned in the Guide can be solved
easily without a service call.
Troubleshooting Guide
Problem
Possible Cause
Probable Correction
The machine doesn’t
operate.
The ice maker is unplugged.
Plug the ice maker in.
The fuse is blown. Breaker
could be flipped.
Replace fuse. If it happens again, call for
service to check for a short circuit in the unit.
The ice maker power button is
set at OFF.
Switch the ice maker power button to ON.
The ice storage bin is full of
ice.
Remove some ice cubes. Be sure the ice-full
probe is free of ice.
The water doesn't
feed in after the
machine starts.
The water supply tap is turned
off.
Turn on the water supply tap.
The water supply pipe is not
properly connected.
Reconnect the water supply pipe.
Machine makes ice,
but bin does not fill
up with ice.
The condenser may be dirty.
Clean the condenser.
The air flow to the ice maker
may be obstructed.
Check the installation.
The ambient temperature and
water temperature are high, or
unit is near some heat source.
Check the installation.