Manual

Leveling the ice maker

It is important for the ice maker to be leveled in order

to work properly. Otherwise water will not flow

properly through the evaporator (ice mold). The

ice production will be less than normal, and may

be noisy. The unit can be raised or lowered by rotating

the plastic sheaths around each of the four rolling

casters on the bottom of the machine. If you

find that the surface is not level, rotate the casters

until the ice maker becomes level. You may need

to make several adjustments to level it. We

recommend using a carpenter’s level to check

the machine.

1. Place a carpenter’s level on top of the unit to see if the ice maker is level from

front to back and side to side.

2. Adjust the height of the casters as follows:

Turn the leveling casters to the right to lower that side of the ice maker.

Turn the leveling casters to the left to raise that side of the ice maker.

You will find that the casters make it easy for one person to move the machine.

This is useful for cleaning and sanitizing the surface on which the ice maker is

installed because it allows you to move the unit and have easy access to the

surface to be cleaned.

IMPORTANT: When the ice maker is ready to be installed in a cabinet or directly on

the floor, you must adjust the feet to level the ice maker and lock the rollers. If the

floor is level, just revolve the two front feet to touch the floor.

Reversing the door swing

Tools needed: flathead screwdriver, Phillips screwdriver; needle nose pliers

IMPORTANT: Before you begin, unplug the ice maker or disconnect power.

To remove door from hinges:

1. Using a flathead screwdriver, unscrew the axis from the hinge 1. Set aside.

2. Open the door about 20°around the bottom hinge 2 axis, then lift the door off

the bottom hinge 2 and set door aside.

To replace door on hinges:

1. Using a flathead screwdriver, remove the plug buttons from the screw holes

opposite the door hinges, top and bottom. Set aside.

2. Replace the axis on the door hinge 1 and tighten it firmly. Remove the door

hinge 1 and place it on the opposite bottom side.

down