Manualshelf

Operating instructions

ManualsBrandsBlaze King ManualsHome building and DecorKING KEJ1107
31323334353637383940
32 Date Printed: 4/7/11
File: G:/pubdata/Manuals\english manuals\OM-KE/PE.pub OM KE/PE 1006 Version 1.10 Revised: December 2010
Optional Accessories
OUTSIDE AIR KIT, KEJ and PEJ (PIN 1726B)
REQUIRED FOR: ALL MOBILE HOME INSTALLATIONS
OPTIONAL FOR: ALL RESIDENTIAL INSTALLATIONS
TOOLS NEEDED FOR INSTALLATION
1. 1/4" or 3/8" drill motor
2. Saber saw
3. Saber saw wood & metal blades
4. 5/16" nut driver or wrench
5. 7/16" wrench
6. Small tube of hi-heat silicone
The outside air inlet hose is a flexible tube to bring outside air for combustion into the stove from outside the residence,
through the wall or up through the floor. The flexible tube will allow some adjustment over or around floor joists or
plumbing. DO NOT CHANGE THE STRUCTURAL INTEGRITY OF THE FLOOR. This air hose must be kept open at all
times to provide outside air for combustion.
INSTALLATION (both models)
1. Set floor protector and stove in location for marking holes in accordance with the dimensions listed on the label and
figures of these instructions.
2. Check that the intended location will not interfere with floor joists, ceiling wiring or plumbing.
3. Mark the positions for the tie down and the hole for the outside air pipe.
4. Move the stove and using a saber saw with a suitable blade, cut a 6-1/2" hole for the outside air pipe. Drill a pilot
hole for the tie down.
5. Install the outside air cap on the bottom of the main tube with two #10 x 3/8" screws.
6. Install the outside air pipe to the outside air flange and collar with two #10 x 3/8” sheet metal screws.
7. Install the outside air pipe through the floor. Drill pilot holes and attach the outside air flange to the floor with four ¼”
x ¾” screws.
8. Position the stove in its intended location. Secure to floor with ¼” x 3” lag screws, or if you have a leg model use
Blaze King kit # ZR8039 (leg anchor kit)
9. Attach the outside air hose to the outside air cap with the outside air hose clamp. Push the other end of the outside
air hose into the outside air flange and seal with high temperature silicone.