Service manual

Operating Instructions
Samsung Electronics 4-11
Choosing a Connection
The following diagrams show common connection examples that can be used for connecting your DVD player to a TV or other equipment.
DVD-709
Before Connecting the DVD Player Connecting to a TV (For Video)
R L
ANALOG AUDIO OUT
R L
VIDEO OUT
S-VIDEO OUT
AV
TV
DVD
PLAYER
Connecting to a TV
• Method 1
DVD Player + TV with Video Input Jack
• Method 2
DVD Player + TV with S-Video Input Jack
• Method 3
DVD Player + TV with Scart Input Jack (Audio & Video)
• Always turn off the DVD player, TV, and other
components before you connect or disconnect any cables.
• Refer to owner’s manual of the additional compo-
nents you are connecting for more information for those particular components.
AV Cable
(included)
S-Video Cable
(included)
Scart Cable (not included)
Good
picture
Basic Audio
(In case of
Method 1 or 2)
Best picture
(If RGB is selected in
SETUP MENU)
Better
picture
Video Input Jack
Audio Input Jacks
S-Video Jack
Method 1
Method 2
Scart Input Jack
Method 3
TV (Normal, Widescreen, Projection, etc..)
OR
Choosing a Connection (Cont’d)
DIGITAL
AUDIO OUT
R L
ANALOG AUDIO OUT
R L
AUDIO
SYSTEM
DVD
PLAYER
Connecting to an Audio System
Method 1 Method 2
Analog Audio Out
Audio Input Jacks
Digital Audio Input Jack
Dolby Digital Decoder2ch Amplifier
Digital Audio Out
Rear Panel
ANALOG AUDIO OUT
R L
VIDEO OUT S-VIDEO OUT
TV SYSTEM SELECT
NTSC SECAM
PAL
AV
Connecting to an Audio System
• Method 1
DVD Player + 2ch Stereo Amplifier or Dolby Pro Logic Decoder
• Method 2
DVD Player + Amplifier with Dolby Digital Decoder/DTS Decoder
NOTE
You can build up the optimum AV system by following the connection examples on this page and the previous page.
SCART JACK