User manual

25
 If more than one number is programmed the Control Panel will continue to dial the number(s)
until a recipient presses the third response key.
 If no phone number is programmed, the Control Panel will not dial.
Call Acknowledgement
When the Control Panel makes Voice Report, there are 3 responses available for the recipient to
receive the call, by pressing 1, 0 or 9 key on his telephone set.
Press 1:
 The Control Panel will open a one-way listen only channel for 2 minutes for you to listen
to what is happening on the other side.
 During the last 20 seconds of the 2-minute period, the Control Panel will sound a beep to
remind the recipient. Press 1 again to extend another 2 minutes.
 When the 2-minute period expires, the Control Panel will automatically hang up and dial
the next number.
Press 0:
 The Control Panel will hang up.
 The Control Panel will continue Alarming.
 The Control Panel will dial the next number.
Press 9:
 The Control Panel will hang up.
 The Control Panel will stop alarming and stop dialling.
The panel will also stop reporting if 2 call recipients pressed 1 or 0 to acknowledge the report
If the call recipient hangs up the telephone without any acknowledgement, the Control Panel will
redial the telephone to retry the report for a maximum of 5 times.
Auto Redial
 When only one telephone number is stored and the number is engaged, the Control Panel will
automatically redial up to 5 times with an interval of 80 sec. between each attempt.
 When more than one telephone numbers are stored, the Control Panel will dial according to
priority order. If the number being dialled is engaged, it will try the next number. Each
number will be tried up to 5 times and the interval between each attempt is 20 sec.
 The Control Panel will redial the telephone numbers for up to 3 cycles, 15 times maximum.