REVERSE CAMERA RC 1.1 Enjoy it.
CAUTIONS Safety Notes • Unit does not record video. This vehicle security system has been manufactured according to established safety guidelines. However, dangers may still occur if the safety notes in this manual is not observed. This manual is intended to familiarize the user with the reverse camera important functions. Read this carefully, prior to using the reverse camera. Keep this manual in an easily accessible location.
SPECIFICATIONS Features CMOS Image Sensor PAL TV System Effective Pixels 750TVL Image Resolution 25 Frame Per Second Exposure & Gain Control 1/60~1/100000sec Electronic Shutter Auto White Balance Illumination Min. Horizontal View Vertical View Diagonal View DC12V Voltage Current DC9-16V Operating Voltage Range Operating Temperature Storage Temperature Protection Grade RCA/6 PIN DIN Lens RC1.1 720 (H) x 480 (V) 0.2 Lux/F 105°H 95°V 170°D 29.
INSTALLATION DIAGRAM a) Reverse Camera a) With Parking Line White Blue b) Remove Parking Line White Blue Display Monitor/ Car Radio Black Wire (Ground) Red Wire Reverse Camera P R N D Reverse Light L 2 Reverse Trigger Ground the wire through the exterior body of the vehicle and keep connection intact. b) Front Camera Display Monitor/ Car Radio White Black Wire (Ground) Red Wire Blue ACC Front Camera Ground the wire through the exterior body of the vehicle and keep connection intact.
After Installation TYPE 3 TYPE 2 TYPE 1 INSTALLATION LOCATION 1 Remove one side of the reverse light socket from its housing then remove the bulb from its socket. 2 Connect the reverse light power cable to the camera, screwn the housing & camera back into position with a screwdriver. 1 Use a screwdriver to remove the original hatch handle 2 Mount the camera where the original hatch handle used to be 1 Remove the rotating mount before installation.
FRONT / REVERSE CAMERA INSTALLATION FRONT/ REAR VIEW DISPLAY & PARKING LINE Reverse Camera Wiring (Remove Parking Line) Reverse Camera Do not cut the wires when using as reverse camera. Reverse Camera Cut blue wire when using as reverse camera to remove parking line. Front Camera Wiring (Flip Viewing Display & Remove Parking Line) Front Camera Cut white & blue wires when using as front camera to flip viewing display & remove parking line. Reverse Camera Do not cut the wire when using as reverse camera.
TROUBLESHOOTING If any of the following problem occur, please resort to Troubleshooting for the possible solutions. Consult Blaupunkt authorized dealer if problem persist. Problem Display monitor / car radio does not show reverse view when reversing. Reverse view does not show even after restarting the display monitor/ car radio. Reverse view does not show even though power supplies of the reverse light or the rear car plate light is properly connected. Solution Restart the display monitor / car radio.
Designed and engineered by Blaupunkt Competence Centre 1 331 21 012 32 01
