Operation Manual

34
Storing stations
Storing stations manually
➮ Select the required FM1 / FM2 /
FMT memory bank or MW / LW
waveband (MW and LW are not
available on the Essen CD33).
➮ Tune into the station.
➮ Press one of the station buttons 1 -
6 : for longer than one second to
store the station to that button.
Storing stations automatically
(Travelstore)
You can automatically store the six sta-
tions with the strongest reception in the
region (only for FM). The stations are
stored in the FMT memory bank.
Note:
● Stations that were previously
stored in this memory bank are de-
leted in the process.
➮ Keep the BND•TS button <
pressed for longer than two sec-
onds.
The station storing procedure begins.
“T-STORE” appears in the display. After
the process is completed, the station
stored in FMT memory location 1 will
be played.
Listening to stored stations
➮ Select the memory bank on which
the station was stored.
➮ Press the station button of the sta-
tion you want to listen to.
Scanning receivable stations
(SCAN)
You can briefly play all the receivable
stations. You can set the scanning time
to between 5 and 30 seconds in the
menu.
Starting SCAN
➮ Hold down the MENU button 7 for
longer than two seconds.
Scanning begins. “SCAN” appears
briefly in the display followed by the
current frequency (which flashes).
Stopping SCAN and continuing
listening to a station
➮ Briefly press the MENU button 7.
Scanning is stopped and the station that
was tuned into last will remain active.
Setting the scantime
➮ Press the MENU button 7.
➮ Keep pressing the or button
5 until “SCANTIME” appears in
the display.
➮ Set the required scantime using
the
and buttons 5.
When you have finished making your
changes,
➮ press the MENU button 7 twice.
Note:
● The set scantime also applies to
scanning in CD and CD changer
mode.
RADIO MODE