Operation Manual

KC BT 25
ENGLISH
MOUNTING PROCEDURE
1. Stick the 2 sides sticker on top of the 4 drill capsules.
2. Stick the unit on the chosen cabinet.
3. When the drill capsules are stick on the cabinet, slowly remove the unit and will see the 4 drill
capsules stick on the cabinet.
4. Drill the wholes through the 4 capsules on the cabinet.
5. Clean off dirt and store the main unit back to the 4 capsules and screw the needles to the unit
through the holes from the top of the cabinet.
STANDBY
STANDBY MODE
1. Press and hold "STANDBY / FUNCTION" button for 3 seconds, until seeing "STANDBY" light
turns on to red.
2. To activate the unit, press and hold "STANDBY / FUNCTION" button for 3 seconds , until
"STANDBY" light turns off.
RADIO OPERATION
AUTOMATIC TUNING
1. Press the “STANDBY/FUNCTION”button to select”RADIO”mode.
2. Press and hold the “SKIP +” or “SKIP -” button over 3 seconds to start automatic tuning process.
3. When a station is tuned in the tuning process, it will stop automatically and you can listen to
your desired station.
MANUAL TUNING
It is for selecting stations,which cannot be tuned automatically.(manual selection)
To tune a channel manually.
- Skip step 3 in the above procedures.
- In step 2,each time the “SKIP+”or“SKIP-"button is pressed momentarily (0.5 second or
less),the frequency changes by a fixed step:
FM:0.05MHZ steps
MANUAL MEMORY PRESET
1. Choose the desired station by following "AUTOMATIC TUNING" step 1 to 2 in the AUTOMATIC
TUNING procedure.
2. Press "PLAY / PAUSE / MODE" button to enter manual preset station setting.
3. Display will show “P01” flashing.
4. Press "PRE - / ALARM 1" or "PRE + / ALARM 2" button to choose preset station number.
5. Press "PLAY / PAUSE / MODE" button to confirm chosen preset station number.
6. Once all the stations were preset, press the "PRE - / ALARM 1" or "PRE + / ALARM 2" button to
choose your desired station.
AUTOMATIC MEMORY SYSTEM (AMS)
1. Press and hold the “PLAY / PAUSE / MODE” button over 2-3 seconds to start automatic memory
preset.
2. When all stations are tuned in the preset process, it will stop automatically.
3. Once all the stations were preset, press the "PRE - / ALARM 1" or "PRE + / ALARM 2" button to
choose your desired station.
Notes:
- FM can be stored up to 30 stations.
24