Operation Manual

6
Scope of delivery
The scope of delivery includes:
• Car sound system
• Remote control (incl. battery)
• TMC tuner (only for devices with Europe navigation)
• microSD card with navigation data in the microSD
card slot (only for devices with navigation)
• GPS antenna
• External Bluetooth microphone
• Getting started
• Support frame
• Small parts set
• Installation material
• Connecting cable
Placing the device in operation
Caution!
Transport securing screws
Ensure that the transport securing screws at the top side
of the device are removed before the startup of the de-
vice.
Theft protection
This car sound system is protected against theft with a
four-digit code number (code number is factory-set to
0000).
If the code query is activated, the code number must
be entered after every interruption of the power supply
from the vehicle battery.
Note:
In the General submenu of the settings menu, you
can activate/deactivate the code query and change
the code number.
Entering the code number after a voltage
interruption
If the code number is required, a keypad for entering the
code number is displayed.
쏅 Enter the code number via the keypad.
쏅 Press the   button to con rm the entry.
The device is switched on.
Note:
If you entered an incorrect code number, the display
brie y shows Security code incorrect!. Afterwards,
you can repeat the code entry.
Switching on/o
Switching on/o with the rotary/pushbutton
쏅 For switch-on, press the rotary/pushbutton
5 .
쏅 For switch-o , hold the rotary/pushbutton
5
pressed for more than 2 seconds.
Switching on/o via vehicle ignition
If the car sound system is connected with the vehicle
ignition and it was switched o with the rotary/pushbut-
ton 5 , it is switched on or o with the ignition.
Volume
Adjusting the volume
You can adjust the volume in steps from 0 (o ) to 50
(maximum).
쏅 Turn the rotary/pushbutton
5 to change the vol-
ume.
Muting the car sound system (Mute)
쏅 Brie y press the rotary/pushbutton 5 to mute the
device or to reactivate the previous volume.
Main menu
In the main menu, you press the buttons on the touch-
screen to call up the di erent sources and operating
modes.
쏅 Press the
button 2 .
- Or -
쏅 In the current source, press the  ……
 button.
The main menu is displayed.
As long as you do not select a new audio source, the
last active audio source is played back.
Scope of delivery | Startup