Operation Manual

BP Car Phone 3.0 C User Manual
32
Places to Install Microphone
5. Connect the electrical supply cable (red cable) to terminal 30 (permanent positive).
It is absolutely necessary for the ignition input (yellow/black cable) to be connected to the ignition
(terminal 15) in order for the device to be switched on automatically with the ignition. It is advised that
you do not place the ignition input of the device on permanent positive, because that restricts the
device’s functional range. After the ignition has been switched off, the device continues to run for the
programmed time and then switches itself off. The earth cable is connected directly to the vehicle
battery via a 3.15 A fuse, the central earth point or a part of the vehicle body that ensures a safe earth
connection.
6. If available connect the violet cable to the mute output of your car radio.
7. Insulate unused cables so that no short circuits can occur.
8. Connect handset/s, loudspeaker, microphone and antenna/e firmly to the control device using the
plug-in and/or screw joints.
9. Check again to make sure the installation was performed correctly.
10. Insert a activated SIM card.
11. Connect vehicle battery and switch on ignition.
12. Device switches itself on and requests a PIN, if this preset response has not already been switched
off on the SIM card.
13. Enter PIN – telephone registers itself in the network.
14. Set up voice calls and test the hands-free kit.
15. Carry out other activities and/or personal settings as necessary.
A = optimal position
B = suitable alternative
C = suitable to a limited extent
Installation of Microphone
Adhesive tape for smooth (even) surfaces
Direction of Speech