Operation Manual

BP Car Phone 3.0 C User Manual
31
3. Select places for installation and install the control device (TPU), handset, loudspeakers, microphone
and antenna taking into account the cable lengths and installation instructions. When drilling holes make
sure that no vehicle parts become damaged. Use cable bushings where holes have sharp edges.
4. Install the microphone ME15, supplied for the hands-free kit, in accordance with the installation
sketch (Picture Installation of Microphone ); the best distance from the mouth is approx. 30 cm; airflows
from the ventilation should not go towards the microphone (see also Picture Places to Install
Microphone ). The loudspeaker is then installed (the best position is in the lower front passenger foot
well).
When installing the microphone and loudspeaker, make sure that they are sufficiently far apart to
prevent an acoustic short-circuit. In an especially loud environment the directional gooseneck
microphone ME251 (accessories) can also be used.
GPS Antenna **
GSM Antenna *
FME Jack
for GSM Antenna
VDA Jack
VDA Plug
Control Device (TPU)
SIM card reader
second
Interface
Hands-free microphone
Hands-free loudspeaker
Digital output (max. 200 mA)
On-board voltage – grün
Radio mute – violett
Terminal 15 / 10.8 – 32 Volt
(ignition) – yellow/black
Terminal 30 / 10.8 – 32 Volt
(permanent positive) – rot
3.15 A
S 1
S 2*
1 A
Short connection tot he ground!
black
3.15 A
S 3
Handset
* Neither the GSM antenna or
the retaining element S 2 are
part of the scope of supply.
** The GPS antenna must be
connected to a TPU with
integrated GPS module.
It is not part of the scope of
supply.