Operation Manual

BP Car Phone 3.0 C User Manual
26
All the phone book functions are the same as in operation mode 1. Only limited dialing is possible via the
keypad. Only enabled numbers of the phone book can still be dialed and emergency numbers. These
restrictions also apply to the sending of messages.
Operation mode 3: (as of firmware version 3.05.03 and 3.06.03 GPS)
The restrictions of operation mode 2 apply here as well. Additionally, receiving calls is restricted to
phone numbers which are listed in the phone book. These restrictions do not apply to receiving
messages.
NOTE: In operation mode 1, 2 and 3 the phone can only be used restrictively. This is a security feature,
which is especially suitable for fleet vehicles as a cost-saving measure.
SECURITY SETTINGS
Operation
mode
Available phone memory
Dialing restrictions exist
Restrictions on receiving calls
SIM card
BP Car
Phone 3.0 C
0
X
(1)
X
(1)
1
X
2
X
X
3
X
X
X
(1)
Only one of these is active
TIP: Configure the phone book in operation mode 0 and then switch to operation mode 1, 2 or 3.
The Windows
®
software Phonemanager 3 offers a convenient way of configuring the phone book. It is
available as an option.
9.6.6.2.5 Digital output
This output’s function can be set via MENU > SETTINGS > DEVICE > CONFIGURATION >
CHANGE > DIGITAL OUTPUT and used as an event data logger.
Choose one of the following settings:
- TELEFON ON The output supplies power when the PTCarPhone 3 is switched on
- RING The output supplies power with every ringtone for one second
- SWITCH The output is switched by a command via SMS
It can be switched ON, OFF or for a five second pulse.
NOTE: Refer to the installation instructions to connect the digital output cable.
9.6.6.2.6 Data logger
To look at the data logger’s memory status select MENU > SETTINGS > DEVICE >
CONFIGURATION > CHANGE > DATALOGGER. Settings can be carried out here and data can be
sent.
MEMORY STATUS: