Operation Manual

Tapping on ‘Heart Rate’ in Settings will show a list with the previously
paired sensors.
Note: if Bluetooth, or Heart Rate category sensors were disabled, the
device will notify the user and prompt if settings should be changed for
an enabled Bluetooth and sensor feature.
This list is grouped and ordered based on the range of the sensor, and
its last known connection date.
The first item would be a connected and present sensor. If there is no
connected sensor, the sensors in range will be shown, and under them
the sensors that are paired with the device, but are not in range.
These list items will be further ordered by the date of last connection,
so the latest sensor will be found at the top.
If there are not any paired sensors yet, new ones can be connected by
tapping the plus sign on the bottom of the screen.
After tapping the plus sign, the available sensors in range will be
shown.
List of sensors in range
Note: a sensor that is not in range during the attempt, will not be shown
in the list, thus pairing won’t be available.
In HR settings, the icon next to the sensors name is to indicate the
status of the connection to the sensor.
Tap on a sensor, then select ‘OK’ ( ) from the popup dialog to
connect, and select ‘No’, to just select it.
Tap on a sensor, then select bin icon ( ) to forget the sensor.
Sensors can be renamed by tapping on the sensor, then tapping on the
edit button ( ).