Operation Manual

40
Getting started - initial set up
Tip:
If the TV  nds some, but not all, of the Digital channels, the TV is
functioning correctly but the signal being received is not strong
enough. (The signal strength needs to be above 85% - you can see
the signal strength the TV is receiving when you change chan-
nels/ programmes) you will need to increase the signal reception in order to
receive all of the channels available. The most economical way to do this is by
purchasing and connecting a ‘signal booster’ in between the TV and the TV
aerial socket. If this does not solve the problem, you will need to upgrade the TV
aerial to a digital hi-gain compatible aerial
1. Using the RF cable supplied, connect the TV to the TV Aerial wall socket (Fig A).
Connect the power cable to the Electrical outlet (Fig B).
2. Turn on the device with marked ON/OFF switch
3. Insert the batteries supplied into the Remote control and press the Standby
button to power on the TV.
4. You will now be welcomed with the initial set-up screen. If it does not appear, on
the remote control, please press [MENU] then 8-8-8-8 and the menu will appear.
As part of our continuing e orts to reduce energy consumption, we added a
new Ecohome feature (appears on the screen  rst installation). This function
helps reduce energy consumption up 15% compared to other modes. The
image brightness is reduced using Ecohome mode. If this setting does not suit
your environment, you can choose from other modes
Note: the professional mode is the optimal default mode, but consumes
15% more than the Ecohome)
Select your language, country and environment.
Press OK on the remote control and tuning will start.
5. In the next step select your digital boradcasting type. You can choose between
DVB-T and DVB-C*. The analog section will be searched automatically, since
most cable networks includes analog channels.*
6. Select DVB-C if your TV is connected to a broadband cable network. Keep all
default settings as possible. Then press [OK] button to start search.
If DVB-C channels are not found, contact your network provider for the valid "Net-
work ID". Then perform a new search. Press the [MENU], select "Automatic Channel
Search" and enter here the inquired network ID. Start your search with the [OK]
button. *
7. After completion of the following channel search screen is displayed:
Sollten einzelne Sender nicht gefunden werden, kann die Ursache an einer zu
geringen Signalstärke oder Qualität liegen. In diesem Falle könnte der Einsatz
eines Antennenverstärkers oder einer aktiven Antenne von Nutzen sein. Nach einer
entsprechenden Aufrüstung führen Sie bitte eine erneute Kanalsuche durch. Hierzu
siehe >>Menü Programmkanäle.
STANDBY
TV/RADIO
TV GUI
D
ATV
First time installation
Language
1) Connect an RF cable from the TV’s RF-in input to your
TV Aerial socket
2) Select required language and country.
3) Press OK on remote control to start auto tunning
English
Country
Wlcome to setup wizard
Environment Ecohome
UK
Start Exit
OK
Auto Tuning
Country Denmark
Digital Type DVB-C
Scan Type Network Scan
Network ID Auto
Frequency Auto
Symbol Rate Auto
Start
OK
Back
MENU
Auto Tuning Status
Analog Channels found 10
Digital Channels found 10
Radio Channels found 5
Data Channels found
Congratulation you have completed
the tuning process. Press OK to EXIT.
1
EXIT
OK
1
2
3
4
5,6 *
7
* - only for models with DVB-C tuner