Operation Manual

26
Show/hide the image of a back-up camera
A back-up camera (optional equipment) can be connected to the
Aspen/Chicago IVDM-7003. The camera image is automatically
displayed when the reverse gear is selected if the back-up cam-
era was connected to the device as described in the installation
instructions. In the setup menu you can configure whether you
want to display the image of the back-up camera as horizontal
mirror. That gives the same impression as a rear-view mirror. For
further details, read the section “Selecting the external signal
source” in the chapter “Setup menu”.
Note: To manually display the camera image, press
the REAR button of the remote control or touch the
Rear
Rear
button on the touch screen menu. Press the
button again or touch the center of the monitor to hide
the camera image again.
Introduction
Automatic through connection of telephone calls
If your Aspen/Chicago IVDM-7003 is connected to a hands-free
system for cell phones, the active signal source is muted if a tel-
ephone call arrives and the call is played back using the car sound
system. For this purpose, the hands-free system must be con-
nected to the device as described in the installation instructions.
Traffic announcements and acoustic driving suggestions from a
connected navigation system are not connected through during a
telephone call.
You can change the volume during a telephone call.
1.
On the device: Use the VOL
-
/
+
buttons.
On the remote control: Use the VOL / buttons.
If the volume is changed during a call, this value remains valid
until the volume is changed again during a call.
BA IVDM-7003 Teil 1 GB 03.02.2006, 8:32 Uhr26