Operation Manual

25
FRANÇAIS
ENGLISH
ESPAÑOL
PORTUGUÊS
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
DSC programming
The DSC (direct software control) function
of the car radio offers you the opportunity to
adjust some of the settings and functions
according to your needs and to store these
changes.
The units are delivered with factory settings.
An overview of the basic factory settings is
provided below to enable you to return to
these basic settings at any time.
Should you wish to change a programmed
setting
• Press the DSC key.
Use the toggle switch to implement the
choice and setting of the functions described
below. The display will show the selected
setting.
Select the function by pressing
/ .
Set or select the value by pressing << >>.
Note:
Whether the various settings explained be-
low are available to you depends on the
model of your car radio and its features. This
means, for example, that you will not find
the setting for CDC DISPLAY in the DSC
menu of the Florida RD 168 radio which is
not intended to be operated with a CD
changer. Basically the rule applies that you
are not able to select functions the radio is
not equipped with. Consequently, the set-
tings of these functions don’t need to be
adjusted (see also chapter “Unit overview”).
AM ON/OFF It is possible to lock the
AM area.
AM ON - all areas
AM OFF - FM
AUX IN If another signal source is
to be connected through
the CD changer, input AUX
must be set to ON. Select
the AUX function with the
SRC key. The display indi-
cates “AUX”.
BEEP Confirms functions for
which the key needs to be
pressed down longer than
1 second. The loudness of
the beep can be set be-
tween 0 and 9 (0 = Off).
CLOCKSET For setting the clock time
manually. Refer to “Clock/
time”.
CLK. MAN. Turn off adjustment for
daylight savings time. Re-
fer to “Clock/time”.
CLK. AUTO Automatic time adjustment
with RTS/CT signal. Refer
to “Clock/time”.
CLK. 12/24 Setting of 12 or 24 hour
modes.
CD DISP. Select display NAME,
TIME. Refer to “Select dis-
play mode”.
CDC DISP Display NAME, TIME, or
CD NUMBER when using
CD changer.
CD NAME Appears only when CDs
are played. This function
allows you to name the
CDs. Refer to “Naming
CDs”.
DISP ON/OFF Enables you to set “perma-
nent time display when unit
is off”. The time display is
visible as long as the igni-
tion is on.
EQ ON/OFF This is where you turn the
equalizer function on and
off.
1.BA Alas,Flori,Neva168 gb 08.06.2000, 12:03 Uhr25